AKO PROPlus 1565 Serie Guía Rápida página 24

DIGITAL INPUT control
Input 2 alarm delay
Input 2 polarity:
Normally open – The input is activated on closing the contact
Normally closed – The input is activated on opening the contact
Inact. with door open (time)
Cold room light timing
AUXILIARY RELAY control
Aux. relay configuration**: Pump down control
Pump down duration
Pump down On delay
Press. controller config.:
Combined HP-LP
LP indep. digital input
GENERAL STATUS
Access password (to parameters and set point)
Password to Set Point
Initial parameters (configures the default values and exits programming)
Registry interval
Communication address
Connected sensors:
Sensor 1 Sensor 1 and 2
Sensors to be displayed
Display mode:
One sensor and clock One sensor and text
Display unit
Decimal point
Probe setting:
TEM at S1/REG at S3: Control probe connected in S1 and log probe in S3
TEM and REG at S3: Control and log probe connected in S3
Delay at Start-up
Type of operation (not selectable)
Program version (Information)
Program revision (Information)
* See table page 25
**Parameter not available in AKO-15658/59; the AUX relay is configured as "same status compressor".
Description
Description
Equal compressor state
LP indep. AC input
Description
Sensor 1 and 3 Sensor 1, 2 and 3
Sensor, clock and text
24
1565H051 Ed.01
Units Min Def Max.
(min.) 0 0 255
NC
(min.) 0 0 255
(min.) 0 0 255
Units Min Def Max.
(Sec.) 1 30 1800
(Sec.) 0 60 60
*
Units Min Def Max.
00 00 99
No
No
(min.) 0 15 60
0 1 255
S1
1 1 3
S1 and
r.
ºC ºC ºF
Yes
TEM in
S1
(min.) 0 0 255
Cold