English - KETRON GP 10A Manual De Instrucciones

CONNECTIONS
The GP 10 digital piano is equipped with the following connections in the control panel under the keyboard:
OUTPUTS
: 2 Right and Left audio stereo outputs, to which external amplifiers, mixer consoles or PA systems can be connected.
INPUTS
: 2 Right and Left audio stereo inputs to which keyboards, compact disk drives or other equipment complete with linear
signal output can be connected.
PEDAL
: Socket for the connection of the Sustain pedal to the console of the GP 10.
MIDI In/Out/Thru
: MIDI sockets. The MIDI unit is a digital interface used to communicate and exchange musical data between electronic
instruments equipped with MIDI.
HEADPHONES
: There are two stereo headphones on the left hand side of the instrument under the keyboard. The headphones are used
to practice on your own or to play right through the night without disturbing anybody.
The built-in speakers amplification system is automatically disabled when the headphones are connected.
AMPLIFICATION SYSTEM
The GP 10 is equipped with a built-in stereo amplification system that includes a 2 x 25 W RMS amplifier and a set of wide band speakers
A
MASTER VOLUME
The volume cursor controls the total sound level of the instrument. To adequately reproduce the sound of the piano, you are recommended not
to exceed 50-70% of the total volume, since this value allows you to obtain a sound level comparable with that of a traditional acoustic piano.
KEYBOARD / PEDALS
The GP 10 is equipped with a keyboard of 88 high quality weighed keys, sensitive to the touch.
It also avails of S S u u s s t t a a i i n n pedal that works just like the typical Sustain pedal on the acoustic piano and extends the notes played.
PRESETS
The GP 10 is equipped with 1 1 6 6 P P r r e e s s e e t t s, namely pre-selected voices, which however cannot be programmed. There are 8 keys used to select the
Voices and they are situated on the right hand side of the display. 2 Voices are assigned to each of the 8 keys. When the LED of the V V a a r r i i a a t t i i o o n n
key is switched off, the 8 keys are used to select the sounds written under the keys (Grand, Rock etc.); when the V V a a r r i i a a t t i i o o n n key is lit, they are
used to select the sounds written above the keys ( Upright, Honky etc. ).
The names written on the panel only refer to the Presets (and not to the Programs ).
To select a Preset, check if the LED of the Program key is switched off first.
Here's the L L i i s s t t of the P P r r e e s s e e t t s s :
P.ch.
01 Grand 09
02 Rock 10
03 E. Piano 1 11
04 DX Piano 12
05 Vibes 13
06 Strings 14
07 Pipe 15
08 Pad 1 16
DUAL MODE
The Dual Mode is used to select two Preset Voices simultaneously. If, for example, you wish to play Piano and Strings together, press and hold
the Grand key down and then press the Strings key too. In this case the Strings Voice is denominated 2nd Voice, since it is the second one
pressed. If a Preset Voice amongst the first 8 locations is to be played in Dual Mode with another amongst the second 8, such as Grand and
Choir for example, press the Grand key first and hold it down, then press Variation and then, holding both keys down, press the key relative to
the Choir Voice too. The Dual mode works exclusively with the Presets (and not with the Programs ).
ND
BRILLIANCE / 2 VOICE BALANCE
The Brilliance / 2nd Voice Balance cursor has two different functions:
B B r r i i l l l l i i a a n n c c e e : when you play with just one voice at a time, the cursor controls the brilliance of the sound. To obtain a soft and natural sound
V V a a r r i i a a t t i i o o n n active
Upright
Honky
E. Piano2
Stage
Harps
Choir
Jazz Organ
Pad 2

English

3
GP 10 - GP 10
A