Part Names And Functions - VOX Amplification Adio Air GT Manual De Usuario

Top panel
a. Amp models knob
This selects the amp model. The characteristics and
location of the gain and tone controls in the circuit, as well
as the cabinet response, will change according to the amp
model that is selected.
b. GAIN knob
This adjusts the pre-amp gain of the selected amp model.
This setting will alter the amount of pre-amp distortion.
c. TREBLE, MIDDLE and BASS knobs
These adjust the high-, mid-, and low-frequency ranges.
d. VOLUME knob
This adjusts the volume level of the selected amp model.
e. EFFECTS section
FX1 (effects 1) knob
Turn this knob select the effect type and adjust the effect
parameters. When this knob is fully turned to the left, all
effects are off.
FX2 (effects 2) knob
Turn this knob to select a type of delay/reverb effect. This
knob also controls the depth, or intensity, of the selected
effect. When this knob is fully turned to the left, all effects
are off.
Tip More detailed adjustments can be made to effects by using
Tone Room.
TAP button and TAP/TUNER LEDs
This sets the time for FX2 (delay/reverb effects). The
interval between two presses of the TAP button will be set
as the time. The green LED will blink in accordance with
the specified time.
Tip To set a precise time that matches the tempo of a song,
press the TAP button several times along with the beat of
the song.
Tip Hold down the TAP button for at least 1 second to bypass

Part names and functions

a b c
i
d e
j
effects 2 and turn on the tuner function (→ "Using the
tuner").
f. INSTRUMENTS knob
This adjusts the final output level of the sound that has
passed through the selected amp model and effect.
Tip This knob cannot be used to adjust the output level to the
USB port.
g. AUDIO knob
This adjusts the output level of sound input from the AUX
IN jack, USB port or Bluetooth connection..
h. INPUT jack
This is where you plug in your guitar.
i. (Power) button, LED
Hold down this button to turn on or off the amp.
j. BANK/MANUAL button, BANK LED and USER PRO-
GRAMS (1 through 4) buttons/LEDs
Use the BANK/MANUAL button to select a program
bank, and then press a USER PROGRAMS button to select
the program within the bank. To switch to manual mode,
hold down the BANK/MANUAL button for at least 1
second; the BANK LED turns off. These buttons are also
used to save new programs (→ "Saving a program").
When the tuner function has been turned on, these buttons
will display the tuning status (→ "Using the tuner").
k. WIDE button/LED
Press this button to engage the wide function (LED lights
up). The wide function uses Acoustage technology to
provide an expansive, extra-wide sound field. Press this
button again to turn off the function (LED turns off).
Tip Holding down the WIDE button for at least 1 second
changes the noise reduction setting. Holding down the
WIDE button for at least 2 seconds changes the audio
equalizer setting.
10
f g
h
k l m