MANAGE CHIME NOTIFICATION
Select a Tune
The four button switch and indicator LED (G) on the chime are used to
select the desired tunes for the chime. (Figure 10)
1. Make sure that the chime is powered (batteries or wiring).
2. Press "FS" button (Figure 10) one or more times to cycle through the
tunes for the front door pushbutton. Do not press "FS" button after
desired tune plays.
3. If rear door pushbutton is installed, press "RS" button (Figure 10) one
or more times to cycle through the tunes for the rear door pushbutton.
Do not press "RS" button after desired tune plays.
G
Note: Press buttons with light
fingertip pressure. Do not use
tool to press buttons.
FIGURE 10
Set Tune Duration
1. Once the tune is selected, the time the tune plays can be
adjusted to one of four durations:
• Press the "CUT" button (Figure 10) one or more times to select
the play time desired (5, 10, 20 seconds or the full song).
• The desired play time is indicated by the LED indicator as
outlined in the table below:
Length of Tune Played
5 sec.
10 sec.
20 sec.
Full Song Played
Adjust volume
While the tune is playing, press "VOL" button (Figure 10) one or more times
to cycle through three volume levels.
Regulatory Information
The user is cautioned that changes or modifications not expressly
approved by the party responsible for regulatory compliance could
void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC rules.
This device complies with RSS-210 of the Industrial Canada Rule.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
4
Frequency of Flashing LED
Flashes once every second for 20 seconds.
Flashes 2 times, delays for 2 seconds, then
repeats for 20 seconds.
Flashes 3 times, delays for 2 seconds, then
repeats for 20 seconds.
LED is illuminated continuously for 20
seconds.