Installing Magicsafe; Tools Required - Waeco MagicSafe MS620 Instrucciones De Montaje Y D’uso

MS-620.book Seite 53 Dienstag, 18. Oktober 2005 3:04 15
MagicSafe MS620
6

Installing MagicSafe

Note
If you do not have sufficient technical knowledge for installing and connecting
the components in vehicles, you should have a specialist install the alarm sys-
tem in your vehicle.
6.1

Tools required

For installation and assembly you require the following tools:
Measuring ruler (see fig. 3.4, page 4)
Centre punch (see fig. 3.5, page 4)
Hammer (see fig. 3.6, page 4)
Drill bit set (see fig. 3.7, page 4)
Drill (see fig. 3.8, page 4)
Screwdriver (see fig. 3.9, page 4)
For making and testing the electrical connection the following tools are required:
Diode test lamp (see fig. 3.1, page 4) or Voltmeter (see fig. 3.2, page 4)
Insulating tape
Heat shrinking sleeve
Hot air blower (see fig. 3.10, page 4)
Crimping tool (see fig. 3.11, page 4)
Soldering iron if required (see fig. 3.12, page 4)
Solder, if required (see fig. 3.13, page 4)
Cable bushing sleeves, if required
To secure the receiver and the cables you may require additional screws and cable
binders.
6.2 Installing the control device
➤
Select a suitable installation location (see Fig. 5, page 6).
When selecting the installation location, observe the following instructions:
Install the control unit
– In the vehicle interior
– With the main connection cable facing downwards
– Under the dashboard
– Not in areas where strong electrical fields can interfere with it, e. g. ignition
cables or central controller electronics
– Not directly at ventilator nozzles.
➤
Where possible use existing drill holes in the vehicle.
Installing MagicSafe
53