Tabla de contenido
Idiomas disponibles
Idiomas disponibles
LP GAS CYLINDER (TANK) RUBBER SEAL INSPECTION:
•
Inspect propane tank valve rubber seal for cracks, wear
or deterioration prior to use. A damaged rubber seal can
cause a gas leak, possibly resulting in an explosion, fi re
or severe bodily harm.
•
Inspection should be done each time propane tank is
connected to grill, has been refi lled, exchanged or has
not been used for more than 60 days.
•
Do not use a propane tank with a damaged rubber
seal. Exchange tank or have rubber seal replaced at a
qualifi ed propane fi lling station.
INSTALLING THE LP GAS CYLINDER (TANK)
ONTO THE GRILL:
1. Check that the cylinder valve is closed by turning knob
clockwise. Inspect cylinder valve rubber seal for cracks or
deterioration. Do not use propane tank with damaged seal
as a gas leak may occur.
2. Place cylinder in tank holder in an upright position.
3. Orient cylinder so valve opening faces right side of the
grill.
4. Fully tighten tank holder screw.
HOSE & REGULATOR SPECIFICATIONS AND INSTALLATION:
•
DO NOT attempt to connect grill, as purchased for LP (propane) gas, to any other fuel supply
source such as a natural gas line. For dual fuel grills that can be converted to natural gas, a
3 Embers conversion kit must be purchased and installed for use with natural gas.
•
DO NOT use any other pressure regulator/hose assembly other than the one supplied with your
grill. Replacement pressure regulator/hose assembly must be part No 7480-155-7480-0, which can be
obtained by contacting customer service at 855-735-9922.
•
DO NOT attempt to adjust or repair a regulator. The regulator is designed to operate at a
maximum output pressure of 11 inches of water column (2.74 kPa).
•
Ensure the tank valve is CLOSED prior to connecting the LP gas cylinder to your grill. Turn the
valve knob clockwise to properly close the valve. Read and follow all instructions and warnings
on the supply hose safety tags. Read and follow all warnings in this manual concerning the safe
use of LP gas cylinders and the hose and regulator before connecting cylinder to grill. Read and
follow all warnings on the LP cylinder.
Tank holder screw
WARNING
Good
Rubber Seal
Damaged
Rubber Seal
6
Capítulos
Tabla de contenido
Solución de problemas
