Sealing; Validation Of The Sealing Process; Registration Of Sealing Parameters - Faro FS1010 Istrucciones De Uso

Adjust the sealer so that on the one hand the seam keeps closed after sterilisation and on the
other hand fibre free peeling is possible.

8.3 Sealing

Before you start sealing, check if the temperature of the sealer is suitable for the material.
If not, adjust the sealing temperature.
If the sealer is ready to seal, start the motor and feed in the material on the left side. The
pouch will slide through the machine. When the pouch leaves the machine it will be sealed.
This is indicates by three stripes over the entire pouch.
The pouch/ roll must be placed with the paper side facing downwards.
Take care of the norm regarding the maximum filling of the pouch. Feed in the pouch
carefully because otherwise there might be a bad seam.

8.4 Validation of the sealing process

To assure proper settings of the sealing parameters, the sealing process must be validated and
the strength of the seam must be tested.
We recommend annual service and revalidation. Please contact your dealer or the
manufacturer of the sealer.
Within a validation the parameters of the sealer will be checked with external instruments.
On top of that, a strength test will be carried out.
For frequent testing a seam can be set to the manufacturer/ dealer for carrying out a strength
test.

8.5 Registration of sealing parameters

This device is equipped with a RS232 port. Via this port the process parameters can be
registered.
The communication parameters must be adjusted as follows:
Baud rate=38400/ Data bits=8/ Parity=none/ Stop bit=1/ RTS=on / DTR=on
When the sealing temperature and sealing force are within the permissible deviations, the
following data is registered during the sealing: set values of sealing temperature, sealing
strength and sealing speed and the current sealing temperature.
For data recording, the C-LOG record system is available as an accessory. This is connected
with a null modem cable to the sealer. Alternatively, data can be recorded with a
documentation system.
Istruzioni d'uso/Instructions for use/Mode d'emploi/Istrucciones de uso
16
Automatic Sealer/Sigillatrice automatica FS 1010 – Rev.00