Installation; Preparation; Set Date And Time; Use Of The "Pressio W - Terraillon PRESSIO W Instrucciones De Uso

54120_S_Pressio W-V10.qxd 6/09/05

5 Installation

5.1 Preparation

Open the battery compartment on the back of the watch.
Insert the batteries supplied as shown in the diagram.
Then close the cover.

5.2 Set date and time

• While in power off mode, press the "SET" button to enter Date/Ti m e
setting procedure and the Month value will begin to flash.
• To adjust the value of Month, press "MEM" button. Pressing once will advance
the flashing value by 1. If the "MEM" button is held down, the value increases automatically.
• Once finished, press "SET" button again to confirm the set value and go to
the next setting.
Follow the steps instructed above to adjust the value of date and time consecutively.
M o n t h D a y Ye a r
24
13:49 Page 24

6 Use of the "Pressio W"

7 Measurement of pulse rate
H o u r M i n u t e
• Sit in a chair with your feet flat on the floor and place your arm
on table so that the cuff will be at the same level as your heart
as shown on the diagram.
• Wrap the pressure cuff around the wrist with the palm facing up.
• Adjust the upper edge of the monitor, it should be about 0.5 cm to 1 cm
below the ball of thumb as shown in the diagram.
• Fasten the cuff on the wrist until it is a comfortable fit. Please note that
the cuff must not constrict. Snugly on the wrist is fine.
• Relax your hand with palm facing up.
• Ensure your wrist is unbent.
• During the measurement, do not move and keep silent to ensure
best accuracy.
Blood pressure naturally differs between two arms, so always measure your blood
pressure on the same wrist, in order to ensure comparability of two readings.
and blood pressure
• Press the "START/STOP" button.
• All display symbols appear for approx. 2 seconds.
This is the initial LCD test.
• When the monitor completes the necessary preparations before
measurement, the last reading result will be shown on the display
for 1 second.
• Then the monitor begins to measure your blood pressure, and you will see
the inflation symbol on the di s play when inflating. During the process
of deflation, the symbol of inflation will turn off and the symbol of deflation
will turn on instead.
• After the measurement is completed, your blood pressure and pulse
will be displayed on the LCD automatically.
About 0,5 ~1cm
25