Briteq COB PAR56-RGB Manual De Instrucciones página 8

ENGLISH
3. CHANG3
Used to set second color changer mode. (only the 3 basic colors: Red-Green-Blue)
 Use DOWN and UP buttons to set the speed for the color changer (SP on the display).
 Press ENTER to confirm  now you can set the speed for the stroboscobe function
 Use DOWN and UP buttons to change the flash rate (F on the display).
 When this is done, press the ENTER button to confirm.
4. CFADE
Used to set color fade mode.
 Use DOWN and UP buttons to set the speed for the color fade (SP on the display).
 Press ENTER to confirm  now you can set the speed for the stroboscobe function
 Use DOWN and UP buttons to change the flash rate (F on the display).
 When this is done, press the ENTER button to confirm.
BLACKOUT
Used to select the behavior of the projector when DMX fails (no DMX detected).
 Press the MODE button until "BLACKOUT" is shown on the display.
 Use DOWN and UP buttons to toggle between:
 BLACKOUT: output turns black while no DMX is detected.
 FREEZE: output based on the last valid DMX-signal is kept on the projector.
Note: as soon as the input detects a DMX-signal, blackout or freeze mode will be cancelled.
DIMMER RESPONSE
Used to select the dimmer mode you want to use with your DMX controller.
 Press the MENU button until DIMMER RESPON is shown on the display.
 Press the ENTER button to select.
 Use DOWN and UP buttons to select the dimmer mode you want to use.
 Once the correct mode is shown on the display, press the ENTER button to confirm.
DMX
Channel Mode
The unit has 3 different DMX channel modes. With this function you can choose the DMX mode you
want to use. Refer to the DMX-charts to see the differences.
 Press the MENU button until CHANNEL CH is shown on the display.
 Press the ENTER button to select.
 Use DOWN and UP button to select one of the available channel modes.
 Once the mode is selected, press the ENTER button to confirm.
OPERATING INSTRUCTIONS
A. Standalone 1unit:
 Just connect the projector to the mains.
 Select one of the automatic modes (STATIC / CHANGE / CHANG3 / CFADE) or select sound
controlled mode (SOUND SENS)
 Refer to chapter HOW TO SETUP to learn how to make the previous settings.
B. Two or more units in master/slave setup:
 Connect the units together. Refer to the chapter "electrical installation" to learn how to do this.
 Select one of the automatic modes (STATIC / CHANGE / CHANG3 / CFADE) or select sound
controlled mode (SOUND SENS) on the master (the first projector in the DMX chain)
 Set all the other projectors in SLAVE mode
 The projectors will now follow the program of the master projector so they all work synchronously.
C. Controlled by universal DMX-controller:
 Connect all units together. Refer to the chapter "Electrical installation for two or more units in DMX-
mode" to learn how to do this (don't forget to address all units properly!)
 Connect all units to the mains and turn on the DMX controller.
Since each unit has its own DMX-address, you can control them individually. Remember that each unit
uses 3, 4 or 5 DMX-channels, depending on the DMX-mode you have selected in the menu. See the
different DMX charts below:
BRITEQ
®
6/40
USER MANUAL
COB PAR56-RGB