Tabla de contenido
Idiomas disponibles
Idiomas disponibles
!
!
4. There is 4 keyholes on the back side of the fireplace casing, place the
mantel in the desired location and drill 4 holes according to the position
of the 4 keyholes. Then insert 4 expansion bolts. Use strong screws to
fix it on the wall, each of the screw needs to come out of the wall for
8mm, ensure that the screw are well fixed then lift the fireplace and
make the keyholes a little higher than the screw's position, then make
the screws slide slowly into the keyholes until it take the whole weight of
the fireplace.
OPERATION
This section will explain the function of each convenient control.
NOTE
The heater may emit a slight, harmless odor when first used. This odor
is a normal condition caused by initial heating of internal heater parts
and will not occur again.
Control Panel Operation
•
A. Buttons and indicators
There are four buttons on the remote controller, and four on the control
panel of the fireplace, each pair of buttons with the same label perform the
same function, the back of it is manual switch near the power cord:
<I/O> button is main power switch;
<ON/OFF> button is power switcher of the electric fireplace;
!
!
!
<DIMMER> button is used to adjust the brightness of simulated flame
and logs;
<FLAME> button for the stepper motor speed control / on and stop
status. ;
<HEAT> button turns the heater is working in low-power status and
the heater is working in high- power status. If the heater already is,
turn it off;
There are four indicators on the control panel:
is the power indicator, it light up when the
turned out when the fireplace is turned off;
indicates the status of the simulated flame and logs. It's brighten
up when the flame simulate component is working, and will be
flashing when you adjusting the brightness of the flame;
indicate click to start a beginning stepper motor speed control loop,
and then stops at the current location;
indicate the heater is working in low-power status
and the heater is working in high- power status.
The red window on the control panel of fireplace is the eye of receiver, do
not cover.
!
!
!
*%!
!
fireplace is working, and
*&!
Tabla de contenido
