Important Instructions - Premier CH-4171V Manual De Instrucciones

!
!
Quick reference guide
I. Prior to installation, please ensure:
1. The rated voltage of your firebox fits the output voltage of your
outlet;
2. The light bulbs in your firebox is in good condition. For checking
this, please follow the instructions for replacing the light bulbs
on section MAINTENANCE.
II. The heater on your fireplace may emit a slight, harmless odor when
first used. This odor is a normal condition caused by the initial
heating of internal heater parts and will not occur again.
III. If your heater does not emit heat, please ensure the Heater Switch is
on. For further information, please consult section Operation of the
Practical User's Guide.
Marks
NOTE
Procedures and techniques, that are considered important enough to
emphasize.
CAUTION
Procedures, which if not carefully followed, will result in damage to the
equipment.
WARNING
Procedures, which if not carefully followed, will expose the user to the
risk of serious injury, illness or death.
!
!
!

IMPORTANT INSTRUCTIONS

WARNING
You should read and always follow the important instructions below to reduce the
risk of fire, electric shock, and injury to persons.
1. Read all instructions before using this fireplace.
2. This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces, such as surfaces near the heater outlet or light bulbs. The grill directly
in front of the heater outlet becomes hot during heater operation. Keep
combustible materials, such as clothes, pillows, furniture, bedding, papers and
curtains at least 3 feet from the front of the unit. Do not cover or block heater
outlet or any ventilation or exhaust opening at any time. Do not use on soft
surfaces where openings may become blocked.
3. Extreme caution is necessary when any heater is used by or near children or
invalids and whenever the heater is left operating and unattended.
4. Do not install the fireplace directly on carpet or a similar surface, which may
restrict air circulation beneath the unit.
5. Always unplug fireplace when not in use.
6. To disconnect fireplace, turn controls to off, then remove plug from outlet.
7. Do not use outdoors.
8. This fireplace is not intended for use in wet locations, such as bathrooms,
laundry areas and similar indoor locations. Never locate fireplace where it may
fall into water container.
9. Do not operate the fireplace with a damaged cord or plug, or if the fireplace has
malfunctioned, or if the fireplace has been dropped or damaged in any manner.
Return fireplace to authorized service for examination, adjustment or repair.
10. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or
the like. Arrange cord away from traffic area and where it will not be tripped over.
11. Do not insert or allow foreign objects to enter any ventilation or exhaust opening
as this may cause an electric shock or fire, or damage the firebox.
12. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do
not use on soft surfaces, like a bed, where openings may become blocked.
13. All electrical heaters have hot and arcing or sparking parts inside. Do not use it in
areas where gasoline, paint, or flammable liquids are used or stored or where the
unit will be exposed to flammable vapours.
14. Do not modify this fireplace. Use it only as described in this manual. Any other
use not recommended by the manufacturer may cause fire, electric shock or
injury to persons.
15. Avoid the use of an extension cord because the extension cord may overheat
and cause a risk of fire. However, if you have to use an extension cord, the cord
shall be 16AWG minimum size and rated not less than 125V/15A or 2000 watts.
16. Do not burn wood or other materials in this fireplace.
**! ! *"!