Parameter Setting (Setup) Via The Front Panel - ORTEA NEXT Icar RPC 5LGA Manual De Operación

ICAR by ORTEA NEXT
10

PARAMETER SETTING (SETUP) VIA THE FRONT PANEL

To access the programming menu (setup): To enter parameter programming the unit must be in TEST mode (first
programming)
or in MAN mode
From the normal measurement display, press and hold
the main display.
If the password has been set (P.21 = ON), the display shows
password using ▲ ▼ and then press
depending on the entered password is user or the advanced level. The password can be defined with parameters P.22 and
P.23. Factory default is 001 and 002 respectively. If the entered password is wrong the unit will show
entered the password, the access is enabled until the unit is re-initialized or for 2 minutes without pressing any key. After
having entered the password, repeat the procedure to access the parameter setting.
Press ▲▼ to select the desired submenu (
The following table lists the available submenus:
Press to access the submenu. When in a submenu, the main display shows the code of the selected parameter (eg
P.01), while the numeric/alphanumeric displays at the bottom of the screen shows the parameter value and / or
description. Press to advance in the selection of items (such as scroll through parameters P.01  P02  P03... ), or
press to go back to the previous parameter. While a parameter is selected, its value can be increased or decreased
with ▲ ▼.
Once the last parameter of the menu has been reached, pressing
submenu selection.
Using ▲▼, select
Alternatively, from within the programming, holding
does not press any key for more than 2 minutes, the system leaves the setup automatically and goes back to normal viewing
without saving the changes done on parameters (like EXIT). N.B.: a backup copy of the setup data (settings that can be
modified using the keyboard) can be saved in the eeprom memory of the RPC 5LGA regulator. This data can be restored
TEST mode
indication
Firmware
revision
MAN mode
Tot kvar
inserted
to move to next digit. If the password is correct the unit will show
... ) that is shown on the alphanumeric display.
 
BAS ADV ALA
COD DESCRIPTION
BAS Access to Base menu
ADV Accesso to Advanced menu
ALA Accesso to Alarm menu
CMD Access to Command menu
CUS Access to Custom menu
EXIT Exits saving modifications.
SAVE Exits without saving (cancel)
to save the changes or
SAVE
for three seconds will save the changes and exit directly. If the user
14 / 40
Total number
of steps
Model variat
Connected
steps
Manual step selection
enabled
for 3 seconds to recall the main menu.
(password entry request instead of
PAS
once more will return back to the
.
to cancel
EXIT
ALL75 mar19
is displayed on
SET
). Set the numeric
SET
or
OK U OK A
. After having
ERR