GB
3.
Removal is the opposite of assembly.
The vacuum cleaner:
Ensure that you have a bag installed in your vacuum cleaner which is approved and rated for drywall dust.
WARNING: Failure to use an approved dust bag in your vacuum will increase the level of airborne dust in
the work area. Prolonged exposure to such dust may cause respiratory harm.
STARTING AND STOPPING TOOL
Make sure that the power circuit voltage is the same as that shown on the specification plate of the machine
and that switch is "OFF" before connecting the tool to the power circuit.
Switching the machine on and off
On/Off Switch
To switch on:
While holding with the left hand on the column and the right hand on
the main handle, Press the rocker switch to the right with the thumb of
the right hand. Anticipate and be ready for the start up torque when the
machine first starts.
To switch off:
Press the rocker switch to the left. After the machine has been switched off, the sanding disc will still rotate for
a time. Take care that parts of your body do not come into contact with the disc and do not set the machine
down while it is still rotating!
Adjusting the rotation speed:
The speed of the machine is variable to suit different tasks. It can be
Speed Adjustment
adjusted from 650/min up to 1600/min by using the thumb wheel. Using
the right thumb, turn in the downward (counterclockwise) direction to
increase the speed and in the upward (clockwise) direction to decrease
the speed. Generally, you should use the higher speed for fast stock
removal and the lower speed for more precise control.
The Half-Moon Door
The sanding plate cover is equipped with a removable half-moon door.
This is to allow the operator to sand right up to the edge or into a corner.
Dust collection will not be ideal while the half-moon door is removed, so
the door should only be removed when necessary and then replaced
immediately. To remove, first shut down the machine and unplug the
power supply cable. Then press the 2 tangs which retain the half-moon
9