AGP GS9FE Instrucciones De Seguridad página 8

3.
Carefully center the new sandpaper disc and press into place. It will be held securely by the hook and
loop backing.
To replace the Hook and Loop Sponge Pad:
The sponge pad must be perfectly flat to get good sanding results. If it is deformed or damaged it will cause
very uneven sanding. Always replace it when damaged. It is hook and loop on both sides, so to Replace it,
peel it away from the hook and loop on the Sanding Plate Base and, taking great care to keep it perfectly
centered, affix a new one.
The Brush Bristles on the edge of the Sanding Plate Cover:
The brush bristles on the edge of the Sanding Plate Cover serve two purposes, they keep the sanding disc
properly aligned with the work surface without gouging and they also help the efficiency of the dust collection
by the vacuum cleaner. These brush bristles will wear with continued use.
The Sanding Plate Cover should be replaced when the bristles are too worn to ensure effective dust collection
and stabilization of the sanding head.
To replace the cover, follow these steps:
Hold the sanding plate in one hand and with the other, using the L-hex
wrench (supplied), first break free the center bolt clockwise (1/8 turn
only!).
Then only use the L-hex wrench to hold the center bolt from turning and
spin off the sanding plate counterclockwise.
Then, press the cover down against the spring and, using snap-ring pliers,
remove the circlip which holds the sanding plate cover to the bracket.
Finally, carefully work the vacuum hose free then lift sanding plate cover
away.
Replacement is the opposite of removal. Don't forget the spring. Entrust
all repairs to an authorized service center.
To install the vacuum cleaner hose
1.
Unplug the machine.
2.
Plug the vacuum cleaner hose bayonet mount into the swivel mount
in the back of the machine. Once the tangs of the bayonet mount
are fully inserted in the slots, hold the swivel mount from turning
and turn the hose bayonet mount clockwise to lock.
GB
8