KOBE CH-122 Serie Instrucciones De Instalación Y Manual De Operación página 12

UNDER THE CABINET INSTALLATION – REAR VENT
Preparation before installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE
VENT OPENING.
Decide the location of the venting pipe from the hood to the outside. Refer to Figure 6.
-
A straight, short venting run will allow the hood to perform more efficiently.
-
Try to avoid as many transitions, elbows, and long run as possible. This may reduce
-
the performance of the hood.
Temporarily wire the hood to test for proper operation before installing.
-
Peel protective film off the hood (if any).
-
For installing under the cabinet with recessed bottom, attach 4-inch wide wood filler
-
strips (not included) on each side. Refer to Figure 7.
Measure and create access opening for electrical wires under the cabinet or access
-
opening for the electrical wires at the rear of the hood.
Remove the screws on the vent cover (rear) and cut along the line of the inner vent
-
cover (rear) opening. Refer to Figure 8.
Cut the vent cover (rear) opening and reverse to the other side. Refer to Figure 9.
-
Reattach the vent cover (rear).
Figure 6
Inner Vent
Cover (Rear)
Figure 8
10
Figure 7
Reversed
Vent Cover
(Rear)
Figure 9