Remote Control - Winix FRESHOME PlasmaWave WACP150 Guía De Uso Y Cuidado

BATTERY REPLACEMENT
1. Remove the screw from the backside of
the remote.
2. Squeeze tabs of battery cover and at the
same time pull cover out of remote.
3. Insert battery as shown and
close battery cover.
4. Always use 3V lithium
battery CR2025
into the remote
control.
3
CRADLE: The remote control
has a separate wall-mountable
storage cradle that can be
conveniently attached to any
wall using a screw.
BATTERY USE
• Always use 3V lithium battery CR2025
into the remote control.
• Incorrect battery usage may cause
battery fluid leakage and/or damage.
• When not using remote control for an
extended period, remove the battery.
• Avoid dropping or damaging the

remote control.

PROPER OPERATING CONDITIONS
• Operate the remote control facing the
air cleaner.
• Operate within 20 feet of the air cleaner.
IMPROPER OPERATING CONDITIONS
• Any location where there is inverter
lighting equipment or electronic
spontaneous lighting equipment.
• When objects or furniture are located
between the remote and the air cleaner.
• When air cleaner unit is located in direct
sunlight, as sunlight may interfere with the
infrared sensor.
• In areas where fluorescent lighting is
flickering due to worn-out bulbs.
• Keep remote control away from direct
sunlight or heaters.
REMOTE CONTROL
A. POWER: Use the power button to turn
the power on and off. A short "beep" will
sound when the unit turns on or off.
B. AUTO: Use the Auto button to engage
the unit into Auto mode.
C. FAN SPEED: By pressing up or down,
the unit will change fan speeds and enter
into manual mode.
D. TURBO: Use this button to switch
from automatic operation and begin the
maximum amount of room air cleaning and
air movement and will remain in Turbo speed
until changed into Auto or Manual mode.
14