Winix FRESHOME PlasmaWave WACP150 Guía De Uso Y Cuidado página 15

CAUTION: Turn off the air clearner
and unplug the electrical cord before
performing any maintenance.
True HEPA Filter Replacement
1. Turn off the air cleaner and unplug the
electrical cord.
2. Remove the front panel by pulling gently
from the lower portion of the panel. Do
not force, the panel should remove easily.
3. Remove the Carbon Pre-Filter and plastic
frame by gently pulling out from the
bottom and down from the top.
4. Remove the True HEPA Filter and dispose
of it.
5. Remove the plastic wrap from the new
True HEPA Filter and insert it with the
arrow showing "air flow" pointing in
toward the back of the top and bottom
of the True HEPA Filter will point out to
the front of the unit.
6. Reinstall the plastic frame and Carbon
Pre-Filter by inserting tabs up into the
air cleaner and gently pushing in at the
bottom tab until the frame fits into place
snuggly.
7. Replace the front panel by hooking the
panel on the top of the unit. Swing the
panel in by pushing gently on each side
of the unit and then lock it into place.
8. Plug in air cleaner and press POWER
button until short "beep" sounds.
9. Press the RESET FILTER button by
gently inserting a paperclip into the
RESET FILTER hole on the control panel.
The light will flash 5 times before a "beep"
sounds to indicate the filter has been
reset. See figure C on page 8 or Diag. 9
to the right.
The air cleaner will take 3-4 minutes to
calibrate the AIR QUALITY sensor. During
this time the sensor lights will flash on and
off. Once the sensor has calibrated, the
lights will stop flashing and the unit will begin
in AUTO mode.
13


“
”
Ž

”