Controls And Indicators - Candy 40013317 Manual De Instrucciones

7.
CONTROLS AND
INDICATORS
Time Remaining
59'
45'
30'
D
B
Time Remaining
C
7 6 5
8
A-Programme Selector - Rotating the knob
in both directions it's possible to select the
desired drying program. To cancel the
selections or switch off the dryer rotate the
knob on OFF.
B- Display Digit - The display shows the
remaining time for drying, the postponed
time in case of delayed start selection and
other notifications setting.
C-Buttons -
1.Start/Pause Button
To start the selected program and/or
suspend it.
2.Super Easy Iron - This option allows to
reduce folds and tangles, thanks to
alternating movements of the drum during
and after drying and automatically, setting
the ironi drying level (the drying level setting
can be modified after the option selection).
The option can be set up to five minutes after
the start of the cycle and is activated only on
automatic cycles.
3.Rapids Button - It's possible switch an
automatic program to RAPID program, up to
3 minutes after the start of the cycle. The
progressive pressure increases the time (30-
45-59 minutes). After this selection to reset
the automatic drying functioning is necessary
to switch off the dryer. In case of
incompatibility, all LEDs flash quickly for 3
times.
A
E
59'
45'
30'
3
4 2 1
4.Drying Selection Button
It allows to set the desired dryness level
editable option up to 5 minutes after the
starting of the cycle:
- Ready to Iron : It leaves the
garments slightly wet
ironing.
- Dry Hanger : To get garment ready
to be hang.
- Dry wardrobe : For laundry that
can be directly stored.
-Extra-dry : To get completely dry
garments, ideal for full load.
This appliances is equipped with Drying
Manager Function. On automatic
cycles, each
drying, prior to the reaching the selected
one, is indicated by flashing the light
indicator corresponding to the degree of
d r y i n g r e a c h e d. I n c a s e o f incompatibility, all LEDs flash quickly for
3 times.
5.Delay Start Button - It allows to
delay the start of the program from 1 to
24 hours in 1-hour intervals. The delay
selected is shown on the display. After
pressing the START button the time
showed decrease hour after hour.
Opening of the porthole with delayed
start set, after re-closing the porthole,
press start
counting.
6. Memo -
store the options set on a cycle.
STORAGE > When the cycle is running
push the button "memory" for three
seconds. The control light "memory"
flashes for three times and stores the
set options connected to the cycle
selected in the flange.
Recall: after
Push the button "memory" for recall the
stored options (not the cycle).
7.Time cycle selection
transform a cycle from automatic to
programmed, up to 3 minutes after the
start of the cycle. The progressive
pressure increases the time in 10-
minute intervals.
After this selection to reset the
automatic drying
necessary to switch off the dryer. In case
of incompatibility, all LEDs flash quickly
for 3 times.
13
to facilitate
level of intermediate
again to resume the
This option allows you to
the selection of the cycle
- It's possible
functioning i s