INSTALLATION
IMPORTANT: the 4 contacts connector should be connected properly so that
the white o-ring is not visible and a clicking sound is heard.
PAY ATTENTION: If the 4 contacts connectors is not connected properly, the
motor will work continuously.
For battery versions: install
the battery box on the wall
underneath the sink and
connect the battery connector.
2a
Caution: make sure to connect
the connectors according to
the indication on the battery
box sticker.
For transformer versions:
plug the transformer into the
2b
electricity socket and connect
the transformer connector
Wait about 10 seconds before
3
you put your hands within the
sensor range.
6
FRom tHe soaP
dIsPenseR
to tHe BatteRY
BoX
to tHe soaP dIsPenseR
FRom tHe tRansFoRmeR
aBout
10
SECONDS
FILLING THE SOAP TANK
If your model is for multifeed application, please refer to the multifeed
installation guide.
unscrew the soap tank from the pump
1
assembly and pull it out of the bottle support.
2
Fill in the liquid soap up to the top line.
3
Insert the bottle inside the bottle support.
screw the soap tank back to the pump
4
assembly. make sure the tank is firmly
secured into place.
Press the refill button located at the back
of the pump assembly until soap starts
5
coming out of the soap dispenser spout. this
operation can also be done using the soap
dispenser remote control Refill function.
NOTE: once the soap in the soap tank has
reached the bottom line the soap tank should
6
be refilled. to refill the soap tank please refer
to steps 1-5.
7