Assembly and Use of the Food Processor Bowl
WARNING: Chopping Blade Assembly is sharp and not locked in place. Before emptying contents
carefully remove lid and Chopping Blade Assembly, holding it by the shaft. Failure to do will result in
risk of laceration.
WARNING: Remove utensils prior to processing. Failure to remove may cause the bowl to be damaged
or to shatter, which may cause personal injury.
WARNING: Never leave the appliance unattended while in use.
CAUTION: Do not blend hot liquids, doing so may cause excessive pressure buildup, resulting in risk of
the user being burned.
CAUTION: Remove the lid from the bowl upon completion of processing. Some ingredients have the
potential to expand after blending resulting in excessive pressure buildup that can pose a risk of
injury.
IMPORTANT: Make sure that the motor base is plugged in for use.
ASSEMBLY
Fig. 15
Fig. 16
1 Review warning and caution statements above
before proceeding to number 2.
2 Place the motor base on a clean, dry, level surface
such as a counter or table top.
3 Align and lower the Bowl onto the motor base.
(Fig. 15) Handle should be aligned slightly to the
right of the "LOCK" symbol on the motor base.
4 Rotate the bowl clockwise as far as it will go to
lock in place. (Fig. 16)
5 The bowl can be placed on the motor base two
ways; the handle can be on the front right corner or
the front left corner. (Fig. 17a, Fig. 17b)
6 Holding the desired blade assembly by the top
of the shaft, place it onto the drive gear inside
the bowl. Ensure that the attachment is seated
properly and is standing upright. (Fig. 18)
NOTE: The blade assembly will fit loosely on the
star-shaped post.
7 Add the ingredients to the bowl, making sure that
they do not exceed the highest measured marking
line on the side of the bowl.
1.877.646.5288
16
Fig. 17a
OR
Fig. 17b
Fig. 18
8 Holding the lid from the feed chute, place it on top
of the bowl and turn clockwise aligning the arrow
( ) located on the lid with the arrow ( ) located
on the bowl's handle. (Fig. 19)
9 Plug the power cord into the electrical outlet and
press up on the power toggle ( ) to turn the power
"On".
NOTE: The 64 oz. bowl is not intended for
blending drinks. Do not
overfill.
NOTE: To add liquids during
processing, remove the food
pusher from the feed chute to
drizzle in liquids. Do not remove
the lid while in use.
TIP: Turn the unit down to the
lowest setting before adding
additional liquids.
Fig. 19