Genebre 72501 Manual Del Usuario página 9

Setting date and time
After inserting the batteries for the first time the date will flash on the display. Now, date and time can
be set.
Set date with the selector wheel.
Set month with the selector wheel.
Set day with the selector wheel.
Set hour with the selector wheel.
Set minute with the selector wheel.
That´s it.
PREP
On the display will be shown. Now, the motor will completely move to the installation position
in order to make the installation easier. As soon as the programmable thermostatic head is ready for
INST
installation will be shown on the display. (
press any other buttons! Plug device for coupling ring.
 Mounting.
You can also set date and time via the menu item
thermostatic head does not move to the installation position.
 In case of replacing batteries, the stored time programme will remain active. You should
check the specified time to ensure that.
Mounting
The thermostatic head can be quickly and easily mounted on all valves. It can be installed without grime
and water spots because the heating circuit is not interrupted.
1.
Turn the manual thermostat head up completely, loosen the fastening and
pull the thermostat off of the valve.
2. Screw the connector on the valve or the adapter.
3.
Now, you put the programmable thermostatic head on the connector until
it noticeably clicks into place.
ATTENTION: It must be possible to insert the programmable thermostatic head without applying force,
ensure that the appliance is in the "
 In case of a later installation, please switch in the menu to "
Herewith the installation is facilitated. Only mount it in this position.
Dismounting
 To remove the programmable thermostatic head remove this at the
(with the wheel turn on the highest temperature of over 28 C° to
wait for a short period and then press on the unlocking device to detach
the quick-release catch. Then pull the thermostatic head from the valve.
Adaptation
Initial installation: Press the button
thermostatic head will be able to start its adaptation. The device will adapt itself to the stroke of your
valve body. To do this the valve will now be opened and closed several times to store the end points.
In some cases this process can take a few minutes. After successful adaptation it returns to normal
mode.
 Should adaptation become necessary again, e.g. if your radiator does not cool down in the
- Position, please press in the menu the button
E2
 If the mistake
is shown on the display place the programmable thermostatic head onto the radiator
valve and then take the batteries out for a short time in order to execute a reset.
Confirm with
Confirm with
Confirm with
Confirm with
Confirm with
INST
- any time selected in the menu). Now please do not
TIME
later on. But in case of that, the programmable
INST ON
" or " " position.
MENU
ADAP
until appears on the display so that the programmable
OK
ADAP
until adaptation starts again.
MENU
MENU
MENU
OK
MENU
OK
MENU
OK
OK
OK
valve – coupling ring
INST
" before you install the device.
EIN
EIN
position),
AUS