Drainage Instructions - Kenmore 8000 BTU Manual De Uso Y Cuidado

DRAINAGE INSTRUCTIONS

Manual drainage
1. When the unit stops after the water pan is full,
press the power key to turn off power to the unit,
and then unplug the power plug. Note: Move the
unit carefully so as not to spill the water in the
water pan at the base.
2. Place a water container below the bottom
drainage port of the unit.
3. Unscrew the drain cap and remove the water
plug. Water will automatically flow into the
water container.
Notes
· During drainage, tilt the unit slightly backwards.
· If you see that your water container will not
hold all the water, before it is full insert the water plug
back into the drain port to prevent water from spilling
onto the floor.
· You may use the drainage tube in the bottom drainage port
if it is helpful to do so. See instructions for tube insertion in
Continuous drainage below.
4. When the all the water is drained from the unit, insert the
water plug and retighten the drain cap.
Continuous drainage
1. Unscrew the drain cap and remove the
water plug from the drainage tube port
in the middle back of the unit.
2. Push one end of the drainage tube into
the drainage port.
3. Set the other end of the drainage tube
into a water container or floor drain.
Allow water pan to drain.
Note: If your water container becomes
full, a water backup may occur that
will fill the unit water pan and result in
unit shutdown. Remove the adapter end
and place into another empty container or floor drain.
Allow water pan to drain.
4. When the all the water is drained from the unit, insert
the water plug and retighten the drain cap.
Page 11