Manual Out Of Range Function; Dual Watch; Automatic Out-Of-Range; Display Illumination - Midland G9 Manual De Instrucciones

for 5 seconds.
! Important: be sure that the Emergency function is active! (EMG blinking).
If you decide to change the channel dedicated to the Emergency function, do not forget to make the
same change to all the radios!
To set again the original Emergency channel (P8 DCS 50)
Press the MENU button until the display shows EC on.
Push MENU again and select of
To confirm press PTT or wait for 5 seconds.
! If you dedicate any of the standard channels to the Emergency function, remember to use it only for
this purpose, otherwise you will cause interferences.

Manual Out of range function

This function allows you to know if there are any radios within your range.
EMG
By pushing twice, you will send a request of acknowledge to the other G9 operating within your range and
tuned on the same channel.
If any radio replies, it means that it's within your range and you will receive an audio tone for confirmation.
! This function can be used only if the "Automatic Out of Range" feature is not active.

DUAL WATCH

The Dual Watch allows you to monitor constantly two channels of your choice at the same time.
Enabling - Disabling
Press the MENU button until the display shows DW of.
Select the second channel to monitor by pushing ▲▼.
To confirm your selection, press PTT or wait for 5 seconds. The display will alternately show the channel in use
and the second channel to monitor.
To stop the function, simply press MENU.
When the transceiver detects a transmission on one of the two channels, the Dual Watch temporarily pauses,
remains tuned for 5 seconds on the corresponding channel, giving the user a chance to respond to a CALL. After
this pause, the Dual Watch starts again.
! This function can be activated only if the "Emergency" feature is disabled.

Automatic Out-of-Range

By setting this mode a pair of G9 is transmitting every 30 seconds a data control code. As soon as the contact
between both units is getting lost and one radio doesn't receive this data control code twice consecutively, the icon
OUT starts flashing in the display and you will hear a beep tone.
! This function can be activated only if the "Emergency" feature is disabled.
Activating – Deactivating
Press MENU till the display shows "OUT" and "Or of", select "Or on" (activated) with the ▲▼ buttons.
11
Switch off both radios.
9
Turn them on at the same time.
10
12
13
To disable this function, push MENU till "OUT" and "Or on" are displayed; select "Or of" (disabled) with the ▲▼
buttons.
14
Confirm your selection by pushing PTT or wait for 5 seconds.

Display illumination

If there is insufficient light to read the display, press briefly
5 seconds. Every time the MENU is pressed, the display will automatically light up.

Power save

The battery power saving feature enables a reduction in the consumption of up to 50%; power saving comes on
automatically when the transceiver does not receive any signal for more than 7 seconds. When the batteries are
discharged, the icon
!
The power save is active only if the Emergency function is disabled.
appears on the display: replace the batteries or recharge the battery pack.
EMG
and the display illumination will activate for about
19