Tabla de contenido
Idiomas disponibles
Idiomas disponibles
When operating
unit, clip shoulder strap onto
clamp, stand as shown and check for the fol-
lowing:
• Extend your left arm and hold assist handle
with your left hand.
• Hold throttle grip with your right hand with
finger on throttle trigger.
• Keep engine end below waist level.
• Keep shoulder strap pad centered on your
left shoulder and danger sign centered on
your back.
• Maintain
full weight
of tool on your
left
shoulder.
Always release the throttle trigger and allow
the engine to return to idle speed when not
pruning.
To stop engine:
• Release the throttle trigger.
• Move the QN/OFF switch to the QFF posi-
tion.
PRUNING
_WARNING:
Be alert for and guard
against
kickback.
Do not allow the moving
chain to contact
any other branches
or ob-
jects at the nose of the guide bar when prun-
ing. Allowing such contact can result in seri-
ous injury.
IMPORTANT
POINTS
• Work
slowly, keeping
both hands firmly
gripped
on the pruner.
Maintain
secure
footing and balance.
• Plan cut carefully.
Check direction branch
will fall.
• Watch OL_ for springpoles.
Springpoles ere
small size limbs which can catch the chain
and whip toward you or pull you off balance.
Use extreme caution when cutting small size
limbs or slender material.
• Watch out for branches immediately
behind
the branch being pruned.
If the chain hits
the rear branch, damage
to the unit may
occur.
• Be alert for springback.
Watch out for
branches that ere bent or under pressure.
Avoid
being struck by the branch or the
pruner when the tension in the wood fibers
is released.
• Keep a clear work area.
Frequently
clear
branches out of the way to avoid tripping
over them.
• Long
branches
should
be
removed
in
several pieces.
PRUNING
TECHNIQUE
When ready to cut, accelerate
to full throttle
end apply a light cutting pressure.
DO NOT
use back and forth sawing action.
Second cut
Third cut
First cut
}f
Pruning technique
1.
Make the first cut 6 inches from the tree
trunk on the bottom of the limb. Use top of
guide
bar to make this cut.
Cut 1/3
through the diameter
of the limb.
NOTE:
When making the second and third
cuts, rest the foot of the pruner against the
tree limb that is being cut to prevent whipping
of the branch.
Foot
2.
Next, move 2- 4 inches farther out on the
limb end make a second cut all the way
through the limb.
3.
Then, make a final cut leaving a I - 2inch
collar from the trunk of the tree to avoid
damage to the tree.
DWARNING:
Disconnect
the spark
plug before performing
maintenance
except
for carburetor adjustments.
CHECK
FOR LOOSE
FASTENERS
AND
PARTS
• Spark Plug Boot
• Air Filter
• Housing Screws
• Assist Handle Screw
CHECK
FOR DAMAGED
OR
WORN
PARTS
Contact an authorized
service dealer for re-
placement of damaged
or worn parts.
• ON/OFF Switch - Ensure ON/OFF switch
functions properly by moving the switch to
the OFF position. Make sure engine stops;
then restart engine and continue.
• Fuel tank - Discontinue
use of unit if fuel
tank shows signs of damage or leaks.
12
Tabla de contenido
