General Safety Instructions - Clatronic HR 2603 Instrucciones De Servicio

42849-05-HR 2603
• Before commissioning this device please read the instruction manual
carefully.
• Please keep these instructions, the guaranty certificate, the sales receipt and, if
possible, the carton with the inner packaging!
• The device is intended exclusively for private and not for commercial use!
• Always remove the plug from the socket whenever the device is not in use, when
attaching accessory parts, cleaning the device or whenever a disturbance
occurs. Switch off the device beforehand. Pull on the plug, not on the cable.
• In order to protect children from the dangers of electrical appliances, never leave
them unsupervised with the device. Consequently, when selecting the location
for your device, do so in such a way that children do not have access to the devi-
ce. Take care to ensure that the cable does not hang down.
• Test the device and the cable regularly for damage. If there is damage of any
kind, the device should not be used.
• Do not repair the device yourself, but rather consult an authorised expert.
• For safety reasons a broken or damaged mains lead may only be replaced by an
equivalent lead from the manufacturer, our customer service department or a
similary qualified person.
• Keep the device and the cable away from heat, direct sunlight, moisture, sharp
edges and suchlike.
• Never use the device unsupervised! Switch off the device whenever you are not
using it, even if this is only for a moment.
• Use only original accessories.
• Do not use the device outdoors*).
• Under no circumstances must the device be placed in water or other liquid, or
come into contact with such*). Do not use the device with wet or moist hands*).
• Should the device become moist or wet, remove the mains plug from the socket
immediately*). Do not reach into the water.
• Use the device only for the intended purpose.
Instructions for charging the device
Please lay the razor on a cool, dry surface when charging. Insert the jack of the
mains cable in the mains socket on the razor and insert the plug in a duly installed
230V/50Hz socket. The green LED shows that the razor is charging and it remains
lit until the razor is disconnected from the wall socket.Leave the shaver to charge
for at least 16 hours before using for the first time. It takes from 14 to 16 hours for a
flat battery to be charged.
01.04.2003 8:26 Uhr

General safety instructions

Seite 23
GB
23