Additional Safety Rules - Makita HM0810T Manual De Instrucciones

ENGLISH
1 Bit
2 Change ring
3 Side grip
4 Grip base
5 Lock button
SPECIFICATIONS
Model
Blows per minute..................................................... 2,900
Overall length ...................................................... 428 mm
Net weight .............................................................. 5.5 kg
• Due to our continuing programme of research and
development, the specifications herein are subject to
change without notice.
• Note: Specifications may differ from country to country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to enclosed Safety
instructions.
4
Explanation of general view
6 Switch trigger
7 Hex wrench
8 Rear cover
9 Screwdriver
10 Brush holder cap

ADDITIONAL SAFETY RULES

HM0810T
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. When chipping into walls, floors or wherever
11. Do not touch the bit or parts close to the bit imme-
SAVE THESE INSTRUCTIONS.
11 Lock nut wrench
12 Crank cap
13 Hammer grease
Wear a hard hat (safety helmet), safety glasses
and/or face shield. It is also highly recommended
that you wear a dust mask, ear protectors and thickly padded gloves.
Be sure the bit is secured in place before opera-
tion.
Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
In cold weather or when the tool has not been
used for a long time, let the tool warm up for sev-
eral minutes by operating it under no load. This
will loosen up the lubrication. Without proper
warm-up, hammering operation is difficult.
Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
Hold the tool firmly with both hands.
Keep hands away from moving parts.
Do not leave the tool running. Operate the tool
only when hand-held.
Do not point the tool at anyone in the area when
operating. The bit could fly out and injure some-
one seriously.
"live" electrical wires may be encountered, DO
NOT TOUCH ANY METAL PARTS OF THE TOOL!
Hold the tool by the insulated grasping surfaces to
prevent electric shock if you chip into a "live" wire.
diately after operation; they may be extremely hot
and could burn your skin.