Tectro TP 20 Instrucciones De Uso página 61

I
S T O R A G E
Empty the internal water container (refer to Chapter F)
Clean and replace the filter.
Put the unit in air circulation mode for a couple of hours to ensure that the
inside becomes completely dry.
S t o re cable as shown, protect the unit against dust and store in a dry place
not accessible to children.
Problem Cause
J
No power supply
The unit does
TROUBLE SHOOTING
not function
Water tank indicator is on
In direct sunlight
Windows or doors open, many
people or heat source in room
The unit does
not seem to
Dirty filter
perform
Air inlet or air outlet blocked
Room temperature lower than
selected value
The unit is noisy Unit stands uneven
The compressor Overheat protection probably
does not work activated
Distance too great
Remote control
Remote control signal not
does not
detected by control panel
function
Batteries empty
Never try to repair or dismantle the air conditioner yourself. Incompetent re p a i r s
result in loss of warranty and can endanger the user.
Solution
Connect to a functioning outlet
and switch on
Empty the internal water
container (refer to Chapter F)
Close curtains
Close doors and windows, or
place an extra air conditioner
Clean or replace filter
Remove blockage
Change temperature selection
Place on even surface (less
vibrations)
Wait 3 minutes until the
temperature has decreased, and
turn on the unit again
Make sure the remote control is
correctly aimed at the control
panel
Replace the batteries
4
61