Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Use the provided USB cable to charge the speaker. The charging indicator light will illuminate
green. The green indicator light will go out when the speaker is fully charged.
SWITCHING ON THE UNIT
Press
to switch on the unit. The display will show "HI" briefly and enter a mode.
Press
again. The display will show "sby" briefly and the unit enters the standby state.
If the unit is idle for more than 60 minutes, it will automatically switch to standby mode.
BLUTOOTH MODE
1. When the unit is turned on, repeatedly press S to select the Bluetooth mode.
2. To pair, go to Bluetooth settings on your Bluetooth device and connect to "BBTS-2000".
• Enter "0000" if asked for a pass code.
Mode
Bluetooth
Blue indicator light will flash quickly.
pairing
Paired
Blue indicator light will stop flashing.
NOTE:
Once the Bluetooth device is connected for the first time, the speaker will
remember the paired setting and reconnect to the same Bluetooth device
the next time they are in range.
3. Adjust the volume level by repeatedly pressing
4. During playback, press
again to go to the previous track. Press
NOTE: The operation may not function properly according to the music player
configuration of the Bluetooth device.
5. During playback, press and hold
6. To pause, press
7. To play audio/video from another Bluetooth device, disconnect the speaker from the
Bluetooth device already in use and then press
FM RADIO MODE
1. When the unit is turned on, repeatedly press S to select the FM radio mode.
The radio frequency will be shown on the display.
2. Fully extend the telescopic aerial from the side of the unit for best reception.
3. Repeatedly press
To start automatic tuning, press and hold
scrolling. Tuning will stop when a station is found.
4. Adjust the volume level by repeatedly pressing
once to go back the beginning of the playing track, press
/
to search through the track backward or forward.
. To resume play, press
/
to tune in to the desired station.
EN-3
Status
+
-
/
.
to go to the next track.
again.
to start pairing.
/
for 2 seconds. The frequency will start
+
-
/
.
Tabla de contenido
