Krups 3MIX9000 Serie Manual De Uso página 10

KR-BATT-MIX-2551060-02-new.e$S 05/06/13 15:37 Page16
EN
2.4 C
LEANING
The bowl, spatula, whisks and mixers are all dishwasher safe.
The base support and the mixer must be washed with a damp cloth.
3 -
VEGETABLE CUTTER ACCESSORY: grate, slice, crush and grind (depending on model)
3.1 A
SSEMBLY
Choose one of the following drums depending on the type of food and the desired result:
Drum c8
- Slices: potatoes, red beetroot, carrots, cucumber, cabbage
Drum c9
- Grates coarsely: potatoes, red beetroot, carrots, cheese
Drum c10
- Grates finely: cheese, carrots
Drum c11
- Grinds: dry foods (almonds, walnuts, hazelnuts, parmesan)
- Makes into strands: potatoes
Drum c12
- Crushes: ice
Clip the adaptor (c1) onto the drum holder (c2) and insert the chosen drum into the drum receptacle
turning slightly so that it lodges correctly into its housing. Then position the drum locking ring (c4) (fig. 17).
Insert the base on the runners located on each side of the adaptor (c1) then the drum holder (c2) (fig. 18).
Do not clip on the base (c5) from below (fig. 19).
Position your mixer vertically then insert the adaptor (c1) into the corresponding holes turning slightly until
it locks completely (fig. 20).
Place the 2.5 l container under the vegetable cutter to collect the food (fig. 21).
Connect the appliance to the mains socket.
3.2 U
SE
Place the food into the feeder tude, guiding them using the pusher (c3) (fig. 21).
Set the button to maximum speed.
3.3 D
ISASSEMBLY
Disconnect the appliance.
To disassemble the drum holder (c2), press the button (c6) located at the front of the adaptor and remove
the feeder tube (fig. 22).
Press the button (c7) at the rear to release the adaptor (c1) from the mixer (fig. 23).
Remove the base (c5) by sliding it along the runners located at each side of the adaptor (c1) then the
drum holder (c2).
3.4 C
LEANING
The drum holder (c2), drums (c8 c9 c10 c11 c12), drum locking ring (c4) and the pusher (c3) are
dishwasher safe.
The mixer and the adaptor must be washed with a damp cloth.
Note:
- Always use a plunger to guide the food into the feeder tube, never your fingers, nor a fork, spoon,
knife or any other object.
- When putting away your vegetable cutter, you can slide the base over the feeder tube. (fig. 24).
4 -
BLENDER ATTACHMENT ACCESSORY: mix, emulsify (depending on model)
4.1 A
SSEMBLY
To insert the blender attachment (d1), open the rear hatch (a5) (fig. 8).
Insert the blender attachment and screw tightly (fig. 25).
Connect the appliance.
4.2 U
SE
Depending on the type of preparation, place the ingredients in the container provided (1 l bowl (e) or 2.5 l
bowl (f) (depending on the model) or in a suitable container (bowl or beaker, preferably deep).
The container must be filled to the maximum or two-thirds full to prevent spilling.
Place the blender attachment (d1) into the preparation before turning on the appliance, this will prevent
splashes (fig. 26).
16