Installation; Mounting - Gruppo Ferroli ECOTRONIC tech Instrucciones De Uso E Instalación

EN

2. Installation

Mounting

ATTENTION!
Always make sure the power is completely disconnected before opening the enclosure.
Installation must only be carried out in closed and dry places. To ensure proper operation, make sure strong
electromagnetic fi elds do not exist in the place of installation. The regulator must be separated from the electric
mains by means of an additional device (with disconnection distance of at least 3 mm on all poles), or with a
disconnecting device complying with the current standards. During installation make sure the mains connection
cable and the probe cables remain separated.
1. Remove the cap (A) and undo the Phillips screw underneath.
2. Remove the cover (B) from the base (C).
3. Mark the upper fixing point (D) for suspension and fit the plug with respective screw included in
the supply (E).
4. Hook the enclosure at the upper fixing point and mark the lower fixing point (F) (distance between
holes: 130 mm); insert the bottom plug.
5. Hook the enclosure at the top and fix it with the bottom screw (G).
6. Remove the connectors from the PCB and carry out the wiring according to the diagrams given
in the following section.
7. Close everything, repeating the above steps in reverse order.
C
A
B
G
Cod. 3540V010 - 07/2010 (Rev. 00)
ECOTRONIC tech
D
F
3 mm
E
83