Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Tighten adjust nut
B to raise mower
Loosen adjust nut
B to lower mower
Loosen jam nut A first
NOTE:
Each full turn of the adjustment
nut will change
mower height about 1/8".
• Recheck
measurements,
adjust if nec-
essary
until front tip of blade is 1/8" to
1/2" lower than the rear tip.
- Hold adjustment
nut in position with
wrench
and tighten
jam nut securety
against adjustment
nut.
TO REPLACE
MOWER
DRIVE
BELT
MOWER
DRIVE
BELT REMOVAL
1.
Park tractor
on a level surface.
Engage
parking
brake.
2.
Lower attachment
lift lever to its lowest
position.
3.
Disengage
belt tension
rod (K) from
ock bracket
(L).
CAUTION:
Belt tension
rod is spring
loaded.
Have a firm grip on rod and re-
lease slowly.
4.
Remove
screws
(P) from mandrel
cov-
ers (Q) and remove covers.
5.
Remove
any dirt or grass clippings
which may have accumulated
around
mandrels
and entire upper deck sur-
face.
6.
Remove
belt from electric
clutch pulley
(M), both mandrel
pulleys
(R) and all
idler pulleys
(S).
MOWER
DRIVE
BELT INSTALLATION
1.
Install belt around both mandrel
pul-
leys (R) and around
idler pulleys
(S) as
shown.
2.
Install belt onto electric
clutch pulley
(M)+
IMPORTANT:
Check
belt for proper rout-
ing in all mower
pulley grooves.
3.
Reassemble
mandrel
covers
(Q). Se-
curely tighten
all screws.
4.
Engage
belt tension
rod (K) on locking
bracket
(L).
_, CAUTION;
Belt tension
rod is spring
loaded.
Have a tight grip on rod and en-
gage slowly.
5.
Raise attachment
lift lever to highest
positron.
COMO
USA
PARA AJUST
MIENTO
Su tractor vier
sensor que ex
Cuando el mo
erador trata dE
apticar el fren[
e/motor.
I,
PresioneE
mente y sc
2. Jale hacia
mano (C) i
suelte gr_
y luego su
Aseg_rese
va a sujet_
PARADA
CUCHtLLAS [
• Muevaelin
accesodo a
(disengage,
Clutch
Engac
IMPULSION r
,
Para parar
el pedal de+
MOTOR -
• Moverla p_
posici6n de
pida).
26
Tabla de contenido
