Adam Nimbus NBL Series Manual Del Usuario página 28

EN
The balance will now request the weight of the sample in air by displaying "AIR WT
the item on the pan, or in receptacle if the density kit is used, and press [Setup]. The
weight in air will briefly be shown in the last weighing unit selected.
After completion of the air weighing, the balance will request the weight in liquid by
displaying "LIq wt LIq wt". Submerge the item in the liquid and press [Setup] to start the liquid LIq wt LIq wt
weighing. The weight in liquid will briefly be shown in the last weighing unit selected,
followed by the computed density of the sample displayed as "XX.XXX
Remove the item from the pan and press [Mode] to continue with a new sample or press
[ 0/T] to return to normal weighing.
10.4.4.2
When finding the density of a liquid, it is necessary to weigh a sample of known volume in
air and then in the liquid. The volume of the sample must be entered by the user. The last
known volume is stored for use at any time.
If using the density determination kit, the volume of the plumb is marked on its support,
e.g. 10.123 cc.
Steps:
Press [Mode] and then [Up] and [Down] keys until "
then press [Setup] to enter this chosen density mode.
Density Liquid
When " " is selected, the type of liquid used for the test must be selected:
The volume will be asked for by displaying "VOLvME
volume in cubic centilitres (cc). Enter or change the volume if required, using the keypad
numeric entry method (see section Error! Reference source not found.) and then press
[Setup] to continue.
The balance will now request the weight in air by displaying "AIR WT
plumb supplied with the density determination kit in air on the weighing pan and press
[Setup] to start the air weighing. The value will briefly be shown in the last weighing unit
selected. The balance will now request the weight in liquid by displaying "LIQ Wt
Submerge the glass plumb in the liquid and press [Setup] to start the liquid weighing. The
weight will briefly be shown in the last selected unit, followed by the computed density of
the sample displayed as "XX.XXX
Remove the item from the pan.
Press [Mode] to continue with a new sample or press [
weighing.
If a printer or other serial device is connected then pressing [Print] will print the density
value in g/cc.
© Adam Equipment Company 2015
Density of a Liquid
"
g/cc
Density Liquid
VOLvME" followed by a value which is the bulb VOLvME VOLvME
AIR WT". Place the glass AIR WT AIR WT
0/T  ] to return to normal
 
26
3016612481Rev2.00-Jul15
AIR WT AIR WT". Place AIR WT
g/cc ".
" symbol is displayed and
LIQ Wt".
LIQ Wt LIQ Wt