Installation With Locking Clip; Lap Belt Only Routing Method; Safety Check - UPPAbaby MESA Manual Del Usuario

LAP/SHOULDER BELT STANDARD ROUTING METHOD
WARNING!
Vehicle seat belt must lock; otherwise a locking clip
must be used. See instructions below.

INSTALLATION WITH LOCKING CLIP

NOTE: The locking clip can be found on the underside of the base
(pg. 11). The locking clip can be used FOR CARRIER AND BASE installation
with Lap/Shoulder belt combination when the seat belt does not lock.
1"
28 UPPAbaby MESA Instruction Book
STEP 1: While pushing into the
child restraint, pull the seat belt
tight to eliminate any slack then
pinch both pieces of seat belt
webbing directly behind the latch
plate. Unbuckle the belt without
1
letting the webbing slip.
STEP 2: Thread the locking clip
onto both lap and shoulder belts
1 in from the latch plate.
STEP 3: Re-buckle the vehicle belt.
2
3

LAP BELT ONLY ROUTING METHOD

1
STEP 1: Route the lap belt through both guides on the carrier, and buckle
the seat belt.
STEP 2: Push the carrier into the vehicle seat bight (crease of the seat)
while pulling on the loose portion of the lap belt closest to the buckle.
NOTE: Check that the carrier is still properly leveled.

SAFETY CHECK

Lap/Shoulder Belt Lap Only Belt
• Carrier doesn't move more than 1 in side to side at the belt path
• Belts are secure and untwisted.
• Angle is correct when the vehicle is parked on level ground and the
red line on the carrier is level to the vehicle floor
• Seating position is permitted by both UPPAbaby and your vehicle
manufacturer for use with the type of Vehicle Seat Belt.
• Carry handle is locked in any of the three (3) positions
UPPAbaby MESA Instruction Book
2
1
2
3
.
.
.
29