Sanyo VCC-HD4000P Manual De Instrucciones página 5

■Rear Face
& For connections, see pages 11 and 12.
1
ALARM IN 1 ALARM
ALARM OUT
A B C D E
ZOOM COM
FOCUS
1
Control terminals
When connecting the cable, press and hold
down the protrusion of the terminal, insert the
cable into the terminal, and then release the
protrusion.
ZOOM terminal
A
Used to zoom in/out by connecting an
external switch.
• DC ±(6-12V), +: WIDE, –: TELE
FOCUS terminal
B
Used to perform the focus adjustment
remotely by connecting an external switch.
• DC ±(6-12V), +: FAR, –: NEAR
COM terminal (Earth terminal)
C
ALARM OUT terminal
D
Used to connect to an external buzzer or
lamp.
When an alarm is detected, the device
connected to the terminal notifies that an
alarm is detected.
ALARM IN 1/2 terminal
E
Used to connect an external alarm switch,
infrared sensor, or other device.
It can also be used as a switching terminal
for color and black/white video modes.
IN 2
4
2
ALARM IN 1 ALARM
SD
ALARM OUT IN 2
OUT
ZOOM COM
FOCUS
AC24V
LAN
EX-HDD
6 5 4
2
SD OUT connector (BNC type)
Outputs SD (Standard Definition) video.
3
AC24V / DC12V terminals
Connect this terminal to the power supply.
• When the camera is turned on, the
POWER lamp lights.
4
LAN connector (RJ-45)
Used to connect the camera to your network.
5
EX-HDD connector
Connects this connector to the external hard
disk case (VA-HDC4000) dedicated to use
with this camera.
For details, see the manual for the hard disk
case.
6
HDMI connector
Outputs HD (High Definition) video. Connect
this connector to an HD video device.
MEMO:
Select the SD OUT or HDMI terminal in on the
TV OUT SETTING screen via the network.
POWER
lamp
POWER
DC
GND
12V
3