Mode Switching - Barco SLM G10 PERFORMER Manual Del Usuario

Proj 1
in out
RS
Terminator
Imagen 9-7
Which information is available
serial number
type
run time
remaining run time
number of strikes
Z-AXIS
How to display the lamp menu
1. Push the cursor key ↑ or ↓ to highlight Lamp. (menu 9-26)
2. Press ENTER to select.
The lamp menu will be displayed. (menu 9-27)
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
NETWORK
LAMP
DIMMING
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 9-26
How to switch the constant light output?
1. Push the cursor key ↑ or ↓ to highlight Constant Light Output.menu 9-27
2. Press ENTER to toggle between [OFF], [SLAVE] and [MASTER].
[OFF] fixed power, no power adaptation.
[SLAVE] follows the master projector to adjust the CLO. When stand alone and the light output should be adjusted,
put on slave.
[MAS- master projector to control the CLO in a chain of projectors.
TER]

Mode switching

1. Push the cursor key ↑ or ↓ to highlight Mode.menu 9-27
2. Press ENTER to toggle between [NORMAL] and [ECONOMIC].
normal normal light output
econo-
reduced light output
mic
R5976562S BARCOSLM G10 PERFORMER 01032004
Proj 2 Proj 3
in in
out
RS
unique serial number of the lamp
lamp type
total time the lamp is used in this or other projectors.
time left before the lamp must be replaced Using the lamp longer than the maximum run time may
damage the projector.
Total times the lamp is started up.
Z-AXIS indicación para ajustar el eje Z de la lámpara (véase Reajuste de la de la posición de la lámpara,
en el capítulo Directrices de instalación).
LAMP
Constant Light output [OFF]
Mode [NORMAL]
Serial number :
Article number :
Run time : 10 hours
Remaining run time :
hours
Number of strikes :
Z_AXIS : 100
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 9-27
Proj 4
in
out
RS
R101111
R9840xxx
490
10
9. Modo de servicio
101