Cleaning And Maintenance - Imetec 804A1 Instrucciones De Uso

CONNECTING THE CONTROL UNIT
ATTENTION! This appliance must only be used with the
control unit supplied. The control unit model is specified on
the label sewn onto the product Fig. [B] (5).
• Insert the plug of the control unit Fig. [A] (2) in the socket Fig. [A] (1) to connect the control unit to the
electric blanket.
• The same must be done with the second plug in the double bed model.
• Run the cable of the control unit on the floor next to the bed. Do not crush the cable of the control
unit between the mattress and the bed frame.
• Insert the plug of the control unit in the socket (3).
SWITCHING THE ELECTRIC BLANKET ON AND SELECTING THE CORRECT TEMPERATURE [Fig. C]
ATTENTION!
or under the sheets when in use.
• Turn on the electric blanket by setting the temperature adjustment key on position 2 (maximum
temperature) to pre-heat the bed and cover the bed with sheet and blanket or duvet.
• The LED on the control lights up to indicate that the electric blanket is operating. The bed will be
pleasantly warm after about 15-30 minutes. The time required for heating the electric blanket
may vary depending on the room's temperature conditions. The temperature level of the electric
blanket must be assessed by lying in bed. Do not assess the temperature of the electric blanket simply
by placing a hand on it because your hands are not sensitive enough to heat and do not allow you to
evaluate the heat required by the body.
NIGHT-TIME OR CONTINUOUS USE
• For continuous use, set the control to position 1 (minimum temperature), avoiding position 2
(maximum temperature) in order to maintain the warmth of the electric blanket throughout the
night.
SWITCH-OFF AND DISCONNECTION
• select the temperature adjustment key on position 0 to switch off the electric blanket.
The electric blanket can be washed. Check the washing symbols on the label of the electric blanket
to wash it correctly.
ATTENTION! Always pull the plug out of the electric power
socket before cleaning or maintenance
BEFORE WASHING
• Disconnect the cable of the control unit from the socket Fig. [B] (3).
• Press the sealing levers at the sides of the socket Fig. [A] (2) to disconnect the socket from the plug Fig.
[A] (1).
• Before washing the electric blanket it is important to measure it so as to compare its size after
drying.
MACHINE WASHING
• The electric blanket can be machine washed at a maximum of 40°C with a delicate cycle.
• Use the gentle spin cycle only. DO NOT run an additional spin cycle.
DO NOT place the control unit under the pillow

CLEANING AND MAINTENANCE

.
EN
13