Three Phase Electric Motor; Instructions For Setting And Use; Start-Up. Starting And Stopping Petrol Engine Model; Start-Up. Starting And Stopping Electric Motor Model - Sima HALCON 65 Manual De Instrucciones Original

3.3 THREE PHASE ELECTRIC MOTOR

These models are supplied with three-phase 230/400V electric motor with switch sockets. The extension
cord used must have a minimum area from 4x2, 5 mm
2
will be 4x4 mm . At one end is placed the extender or air base that includes the machine in endowment,
and the other an air jack which is compatible with the output of the switchboard where you go to plug.
The three-phase electric motor models leave the factory are always connected to work at
400V. If necessary connect the machine to a supply voltage of 230V, we change the position of the flat
in the motor terminal box, as shown in the figure below:

4. INSTRUCTIONS FOR SETTING AND USE.

ATTENTION: Must follow all safety recommendations outlined and comply with regulations for
the prevention of occupational hazards of each place.
It must also be read specific instructions petrol engine (Instruction book's own engine).

4.1 START-UP. STARTING AND STOPPING PETROL ENGINE MODEL

 Security locks the handlebar lever M, Fig.3 by pressing against the pipe and pressing the
lock button. During the start-up operation will be fixed in this position even if you
release the handlebar.
 Check engine oil level. If it is below the minimum will not start.
 Open the fuel valve engine.
 Close the throttle. (Not necessary if the engine is hot or the temperature is high).
 Place the handlebar lever gas A, Fig.3 the beginning of his journey, during slight
acceleration.
 Turn the engine switch to the ON position.
 Start the engine pulling the recoil starter handle.
 Let the engine warm up at the low rpm and open the throttle. The machine would now be
enabling to begin the work planned.
To stop the engine, opening up the safety lever M, Fig.3 pressing it against the tube
without touching the block button. When you release the handle, the engine will stop.
Put the motor switch to OFF and close the fuel valve.
For details on operations in the engine, see instruction book's own engine.

4.2 START-UP. STARTING AND STOPPING ELECTRIC MOTOR MODEL

For versions with electric motor, connect the extension cord to the switch outlet A, Fig. 4
and the engine will start by pressing the green button.
To stop machine press the red button B. Fig. 4.
2
up to 25 meters length. For a greater distance it