Lamp Replacement; Lamp Replace Counter - Sanyo PLC-SE10 Manual Del Propietário

Tabla de contenido

Idiomas disponibles

When the life of Projection Lamp of this projector draws to an end, LAMP REPLACEMENT indicator lights yellow. When a

projected image becomes dark or the color of an image becomes unnatural, replacement of Projection Lamp is required.

CAUTION

For continued safety, replace with a lamp

assembly of the same type.

Allow a projector to cool for at least 45

minutes before you open Lamp Cover. The

inside of a projector can become very hot.

Follow these steps to replace the lamp assembly.

Turn off the projector and disconnect AC plug. Allow the

projector to cool at least for 45 minutes.

Remove a screw with a screwdriver to remove Lamp Cover.

Remove 3 screws with a screwdriver and pull out Lamp

Assembly by grasping Handle.

Replace Lamp Assembly with a new one and tighten 3 screws

back. Make sure that Lamp Assembly is set properly. Replace

Lamp Cover and tighten a screw.

Connect AC Power Cord to the projector and turn it on.

Reset Lamp Replace Counter (refer to the section "Lamp

Replace Counter" below).

NOTE : Do not reset Lamp Replace Counter when Projection

Lamp is not replaced.

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering Projection Lamp, give the following

information to the dealer.

G Model No. of your projector

G Replacement Lamp Type No. : POA-LMP50

Be sure to reset Lamp Replace Counter when Lamp Assembly is replaced. When Lamp Replace Counter is reset, LAMP

REPLACE Indicator stops lighting.

Turn projector on, press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT button(s) to

move a red frame pointer to SETTING Menu icon (refer to page 35, 36).

Press POINT DOWN button to move a red frame pointer to "Lamp counter reset" and then press SELECT button. The

message "Lamp replace counter reset?" is displayed. Move the pointer to [Yes] and then press SELECT button.

Another confirmation dialog box appears and select [Yes] to reset Lamp Replace Counter.

Do not reset Lamp Replace Counter except after Projection Lamp is replaced.