JIMTEN T-604 CC Manual De Instrucciones Y Mantenimiento página 29

A A
H H
B B
C C
I I
D D
E E
F F
G G
* If power supply cable is damaged, it must be replaced by the manufacturer, its technical assistance
service or a qualified technician to prevent any
danger.
7.4. REPLACEMENT / CLEANING NON-RETURN
VALVE.
Before starting the replacement / clearing,
discharge several times and (if it was previously
installed) to close the stopcock of the vertical waste
pipe and disconnect the unit from the power supply.
- Remove register to access the unit.
- Remove the 1 1/4" nut (B).
- Release the support flanges attaching the pipe
to the wall in order to move the pipe and to
make the dismantling easier.
- Have a container near to collect water, empty
the discharge pipe by activating the non return
valve clapper.
- Remove the clip nut (C).
- Check or replace the seal support + non-return
joint set (D).
- To assemble the valve, follow the steps in reverse order.
Before operating the waste disposer again, and for the purpose of eliminating air within the discharge insta-
llation, discharge the cistern several times.
T-604 CC WASTE DISPOSER
ELECTRICAL CONNECTIONS SCHEME.
(motor – pressure switch – power cord).
Network cable (A) – Made up of Live (brown), Neutral
(blue) and Earth (Yellow/Green).
Triac cable (B) – Live (brown) to connection 3 of pres-
sure switch (D), faston female.
Network cable (C) Live (brown) to Triac (E).
Triac cable (F) Live (brown) to motor.
Triac cable (G) – Live (brown) to connection 1 of pres-
sure switch (D) and to motor.
Neutral (blue) (H) and Earth (Yellow/Green) (I) faston
male connection.
INSTRUCTIONS AND MAINTENANCE GUIDE - 29