Cleaning & Maintenance - Venta COMFORT PLUS LW15 Manual De Instrucciones

Display Function
6 AUTO Switch Automatic operation on device on or off by briefly
touching the AUTO button
ON: AUTO in the display flashes continuously and device
automatically regulates the rotational speed depending on
the humidity in the room.
When switching on AUTO, the desired humidity (50 %
i
pre-set) flashes twice and then will show the meas-
ured humidity in the room in the HUMIDITY display 1.
If the pre-set humidity is exceeded by more than 5 %,

the fan will switch off after approx. 60 seconds and
no rotational speed will appear in speed display 2. No air
humidification/air purification will take place.
OFF: AUTO in the display is lit continuously, and the device
runs at the set rotational speed 1 - 3.
Set desired humidity 30 – 70 %:
Hold AUTO-button for 3 seconds. The HUMIDITY 1 display
will flash continuously. Set the desired humidity (in 5 %
increments) using the - or + buttons 3. Hold AUTO-button
for 3 seconds again until the flashing in display HUMIDITY
1 and the humidity measured in the room is shown again.
24 EN
CLEANING & MAINTENANCE
7
Attention! Ensure that the device is switched off during any measures
!
and the switching power supply is disconnected from the outlet!
Display Measures
7 WATER Remove upper housing. Fill lower housing with tap water up
to the WATERLINE marking. Place upper housing on lower
housing and put device in operation again.
i
As soon as there is not enough water in the lower housing, the device
is switched off automatically and the WATER display appears. In the
HUMIDITY display 1, two lines will flash and the humidity in the room
is not shown.

To humidify and clean the room air continuously, we recommend
refilling the water in a timely manner.
8 SERVICE Remove upper housing. Drain residual water from lower hous-
ing. Rinse lower housing and disk stack. Fill lower housing with
tap water up to the WATERLINE marking maximum and add the
Venta hygiene additive (for dosage see scale on rear of bottle). Re-
assemble the device. Touch SERVICE display 8 in the display and
hold it for 3 seconds until it goes off.
i For flawlessly hygienic continuous operation, the SERVICE display
indicates a reminder every 14 days that this measure needs to be
carried out.

This measure can be carried out if required, even if the SERVICE
message is not shown. Afterwards, simply touch SERVICE display 8
and hold for 3 seconds. The next reminder will now be shown again in 14 days
with the SERVICE message
Any remaining liquid in the water tray and on the disk stack (white, green-yellow or
brown deposits or discolorations) do NOT impair the function of the device.
For the six-monthly cleaning, we recommend the Venta Cleaner. Please note the
instruction manual included with the Venta Cleaner.
8
EN 25