Tabla de contenido
Consignes de sécurité
FR/CA
Safety regulations
GB/US
JP
安全注意事項
Please read these instructions in full and study all the illustrations before starting to install your light fitting.
GB / US
This light fitting must be installed by a qualified electrician.
Installation instructions
Respect current national regulations for electrical wiring. Make sure the circuit you want to use for this light fitting is
properly installed and protected in accordance with national installation regulations.
At the time of installation and whenever you work on the device, make sure the power is switched off. If this is not
the case, switch off the power at the distribution panel. Switching off at the wall switch is not enough.
The device cannot be modified or altered in any way, since any changes could compromise its safety and make it
Baccarat
dangerous.
The light fitting must be installed so that all its components are out of the reach of children.
Operation
First use: Charge the light fitting fully (the indicator light turns green) and wait for it to go out before recharging it.
To extend your battery life, we recommend carrying out a complete discharge/recharge cycle at least once every 6
months.
To switch the product on and off, push the switch located under the pole.
1h of charge = 1h of autonomy, with a minimum of 9h of charge for maximum autonomy
Full charging time for the light-fitting and its autonomy may vary according to different parameters: battery life, out-
door temperature, humidity...
Charging time is only guaranteed for the charger supplied. (charging time may be different with another power
source such as a PC USB port)
Symbol legend
The light-fitting is designed for indoor installation only.
The equipment is used at a maximum of 50 Volts power. The equipment does not need to be earthed.
IP
This product is designed for internal use. It is not intended to be installed in a bathroom or other damp premises.
20
The light-fitting must not be in contact with water.
Ta:
The light-fitting is designed to work at a maximum ambient temperature of 25°C.
25°C
This light fitting is produced in accordance with European norms and directives.
The product must not be put with the household waste.
Consult the regulations in your country for recycling and disposal. Do not incinerate
Specific LED 1xMax 12W
Panasonic BK-3HGAE - AA/Mignon
- Input: 100-240V AC, 47-63Hz / Output: 5V DC , 2 A (10 W)
cannot be held responsible for modified products.
- 2700mAh typ. (2500mAh min)
Medidas de seguridad
ES/MX
Правила техники безопасности
RU
1.2V - NiMH
,
5
Tabla de contenido
