Power Supply; Solar Panel; Attaching The Antenna; Usb Connection - Num'axes PIE1023 Manual Del Usuario

Figure 4: switch and buttons
MENU button
ON / SETUP / OFF
switch

3. Power supply

3.1. Batteries
The camera runs on 12 AA size batteries (12V power supply to ensure camera good performance of all functions). The product can work with
alkaline or high quality NiMH rechargeable batteries.
Please choose the battery type you're using in the menu option "Battery type" to reach longer operation time.
Before inserting or removing the batteries, the camera must be turned off (switch in the OFF position).
When inserting the batteries, make sure to follow polarity indicated inside the battery slot. Upside down batteries may cause device
malfunction.
Also, we strongly recommend changing the batteries when power icon on camera screen or photo stamp is empty.
NOTE: Don't mix battery types! Different batteries to be used in camera may cause permanent damage not covered by the guarantee.
3.2.

Solar panel

This camera is able to work with most standard 12V/2A lithium battery build-in solar panels.
However, as rechargeable AA NiMH batteries need higher voltage for charging that solar panel can't charge the batteries used in the battery
slots.
3.3. Power adaptor – Security surveillance purpose
This camera can also be powered by an external 12V/2A DC adapter. We recommend removing the AA size batteries when a power adapter is
used. DC power is recommended for security purposes.
4. SD card
Using a memory card is required to operate the camera. When camera is in SETUP mode and no memory card is inserted, the screen displays
"No SD card". The SD slot of the camera has a 32 GB memory capacity.
Before inserting or removing the memory card, the camera must be turned off (switch in the OFF position). Failing to do so may cause loss of
or damage the files already recorded on the memory card.
When the SD card is full, the viewing screen indicates "Memory Full".

5. Attaching the antenna

Screw the threaded base of the antenna onto the socket on top of the camera. Make sure it is securely attached, but do not over-tighten it.

6. USB connection

When camera is connected via USB cable; screen displays "MSDC", press "MENU" once, "MSDC" turns to "PC Cam", camera now can be used as
a PC camera; press "MENU" again, camera exits PC camera mode.

7. Quick start

7.1. How to start the camera?
Switch "ON" the power switch.
NOTE: Camera comes pre-programmed with factory default settings. So for test purpose, user only needs to insert a SD card and batteries then
power on the camera (switch in the ON position).
7.2. How to set the functions?
− Slide the switch to the "SETUP" position to enter setting mode, then press the "MENU" button once to enter camera setting menu.
− Use the navigation buttons "⊳", " ", " " or " " to obtain favoured settings, press "OK" for confirmation and save the preferred
change, press "MENU" to exit current page.
− Slide the switch to the ON position to enable camera to work on PIR.
PIE1023 - Indice A
OK button
Navigation buttons
/ / ⊳ /
14/56