Workzone 44217 Manual Del Usuario página 11

12V Cordless Drill
7. INSTALL DRILL BIT INTO THE
CHUCK [SEE F]
8. USING THE WORK LIGHT
The sight light allows you to keep a
clear view under less illuminated
circumstances. To turn on the light
simply press the on/off switch. When
you release the on/off switch, the light
will be off.
9. HOOK
The hook is convenient for temporarily
hanging the tool. This can be installed
on either side of the tool.
To install the hook, insert it into a
groove in the tool housing on either
side and then secure it with a screw.
To remove, loosen the screw and then take it out.
10. DRILLING WORK
When drilling into a hard smooth surface, use a center punch to mark the
desired hole location. This will prevent the drill bit from slipping off center
as the hole is started. Hold the tool rmly and place the tip of the bit at the
point to be drilled. Depress the switch trigger to start the tool .Move the
drill bit into the workpiece, applying only enough pressure to keep the bit
cutting. Do not force or apply side pressure to elongate a hole.
Note:
If your tool stops working when drilling a hole automatically, it's normal.
This is the electrical protection for battery. Completely release the ON/OFF
switch, then depress it to start the tool again.
Service:
Have your power tool serviced by a quali ed repair person using only
identical replacement parts.
THE RBRC
TM
The RBRCTM Seal (Rechargeable Battery Recycling
Corporation) on the Lithium-ion battery (or battery pack)
indicates that the cost of recycling the battery or battery
Li-ion
pack have already been paid by the manufacturer.
11
[email protected]
SEAL
Charging & Operation
F
Groove
Hook
USA
Screw
AFTER SALES SUPPORT
1800 505 8311
USA