Customer Service - Peg-Perego Prima Pappa Dondolino Instrucciones De Uso

Ocultar thumbs Ver también para Prima Pappa Dondolino:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

EN•ENGLISH
• IMPORTANT: read the instructions carefully
before use. Save the instructions for future
reference.
• PEG PEREGO reserves the right to make any
necessary changes or improvements to the
products shown at any time without notice.

CUSTOMER SERVICE

If parts of the model are accidentally lost or
damaged, use only original Peg Perego spare
parts. Contact the Peg Perego Customer
Service for all repair work, replacements,
information about products, and sale of
original spare parts and accessories, at the
following:
USA:
tel.: 800.671.1701
fax: 260.471.6332
Call us toll free: 1.800.671.1701
CANADA:
tel.: 905.839.3371
fax: 905.839.9542
Call us toll free: 1.800.661.5050
www.pegperego.com
INSTRUCTIONS FOR USE
ASSEMBLING THE HIGH CHAIR
1• When mounting the rockers on the high
chair, take care to position the right
and the left rocker correctly, placing the
exterior side of the rocker on the outside.
The exterior side of the rocker has holes
on the ends for the screw heads.
2• The fi gure shows the correct position for
the rockers on the high chair.
3• Mount the narrow part at the bottom of
the rocker on the high chair as shown in
the fi gure, pushing the long screw with
the short bushing through the hole. Use
the tool that comes with the high chair to
tighten the screw.
4• Mount the wide part at the top of the
rocker on the high chair as shown in the
fi gure, pushing the short screw with the
long bushing through the hole. Use the
tool that comes with the high chair to
tighten the screw.
5• Mount the wheels on the high chair,
pressing until they snap into place and
taking care to insert the ones without
brakes on the front of the high chair.
6• Mount the rear wheels, pressing until they
snap into place.
7• Cut the band.
OPENING THE HIGH CHAIR
8• To open the high chair push the red side
levers down, pressing on the rear frame,
as shown in the fi gure.
9• Open the high chair, lowering the rear
cross bar until it clicks into place.
10• Lower the footrest, as shown in the
fi gure.
11• The high chair is not in the correct
position for use when it is removed from
the packing. To use the high chair, lift it
to adjust it to one of the seven diff erent
heights, as shown in the fi gure. To put
the high chair back into the packing
position, see the instructions below.
BRAKE
12• The high chair has four swivel wheels,
with brakes on two of them. To brake the
high chair, lower the little brake levers on
the rear wheels. To release the brakes, lift
the levers. For your convenience, always
make sure the brakes are set before
carrying out any other operation on the
high chair.
TRAYS
Dondolino comes with 2 trays: a small
tray for the rocking-chair, and a large
tray for mealtimes.
13• To attach the rocking-chair tray, place
it in the position shown in fig. A. Push
the tray all the way in, turning the knob
under the tray at the same time (fig.
B). To remove the tray, carry out the
instructions in the reverse order.
14• To attach the mealtime tray, hook the
back part of the tray onto the high chair
first, as shown in fig. A. Press the red
button under the tray and pull the lever,
while fastening the front part of the tray
(fig. B). To remove the tray from the
high chair, follow the instructions in the
reverse order.
15• Both trays can be adjusted to two
different positions (1 & 2) by turning the
knob under the tray counterclockwise.
Position 3 is used only to fold the trays
up.
SAFETY BELT
16• Make sure that the shoulder strap is
correctly inserted, by pressing on it, as
shown in figure A. Fasten the lap belt as
shown in figure B.
17• To unfasten the safety belt, press the
sides of the buckle (fig. A) while pulling
the lap belt outwards (fig. B).
18• The shoulder straps can be adjusted to
two different heights. Unfasten the safety
belt from behind the backrest by pushing
the buckle downwards (fig. A). Slip the
safety belt out of the sack (fig. B).
19• Next, slip the safety belt buckle through
the other opening in the backrest (fig. A),
and fasten the buckle to the peg, pulling
Tabla de contenido
loading

Tabla de contenido