What To Do In Case Of A Problem; Installation Instructions - BORETTI BIK-97 Manual De Uso

Installation instructions

The installation comes under the exclusive res-
ponsibility of specialists.
The installer is held to respect the legislation
and the standards enforce in his home coun-
try.
Fitting - installing:
Appliance Worktop Cut-out (mm)
Width x Depth
BIK-97 950 x 350
• The piece of furniture or the support in which
the hob is to be fitted, as well as the edges
of furniture, the laminate coatings and the
glue used to fix them, must be able to resist
temperatures of up to 100 °C.
• The mural rods of edge must be heat-resi-
sting.
• The hobs are classified as "Y" class for heat
protection. Ideally the hob should be instal-
led with plenty of space on either side. There
may be a wall at the rear and tall units or a
wall at one side. On the other side, however,
no unit or divider must stand higher than the
hob.
• Ensure that there is a distance of 50 mm
between the hob and the wall or sides.
• Materials which are often used to make work-
tops expand on contact with water. To pro-
tect the cut out edge, apply a coat of varnish
or special sealant. Particular care must be
given to applying the adhesive joint supplied
with the hob to prevent any leakage into the
supporting furniture. This gasket guaranties
a correct seal when used in conjunction with
smooth work top surfaces.
• Not to install the hob to the top of a not ven-
tilated oven or a dishwasher.
• To guarantee under the bottom of the hob
casing a space of 20 mm to ensure a good air
circulation of the electronic device.
• To guarantee between the work top and the
top of the drawer or oven a space of 5 mm to
allow the exit of the air flow.
• If a drawer is placed under the work, avoid
to put into this drawer flammable objects
(for example : sprays) or not heat-resistant
objects.
• The safety gap between the hob and the
cooker hood placed above must respect the
indications of the hood manufacturer. In case
of absence of instructions respect a distance
minimum of 760 mm.
• The connection cord should be subjected, af-
ter builting, with no mechanical constraint,
such for example of the fact of the drawer.
• The installation of the hob in non stationary
sites ( for example : boat ) should be under-
taken by specialists.
How to stick the gasket:
The gasket supplied with the hob avoids all infil-
tration of liquids in the cabinet.
His installation has to be done carelessly, in
conformity of the following drawing.
2 mm
Stick the gasket (2) two millimeters from the
external edge of the glass, after removing the
protection sheet (3).
NL
FR
ES
EN
55