Standard Equipment; Preparing The Machine For Operation; Unpacking The Garden Shredder; Attaching The Chassis - Viking GB 460 Manual De Instrucciones

Risk of injury:
Never put your hands or any
other part of your body or
clothing into the feed chute
or ejection chute.
Risk of injury:
Do not climb onto the
machine.
The On / Off switch is
located on the front of the
machine. Turn the black
rotary knob of the On / Off
switch to switch off the
machine.

6. Standard equipment

Item Designation
A Basic unit
B Right wheel carrier
C Left wheel carrier
D Foot
E Plug
F Wheel
G Retaining ring
H Axle
I Torx screw
M8x40
J Nut M8
K Feed chute ATO 400
L Ejection chute extension
M Guiding plate
0478 216 9905 D - EN
Item Designation
N Ejection chute plate
O Torx screw
P5x20
P Flat head bolt
M6x16
Q Torx screw
M6x16
R Nut M6
S Spanner
T Installation tool
U Hexagon bolt
M14x130
•
Instruction manual
•
Engine instruction manual
7. Preparing the machine for
operation
Risk of injury:
Carefully read the section entitled
"For your safety" (
all the safety instructions before
2
assembling the garden shredder.
Qty.
Strictly observe all torques in the
1
"Preparing the machine for
1
operation" (
damaging the machine.
1
2
In particular, gloves
2 should be worn and
contact with the blades 2
must be avoided.
2
Avoid damage to the machine.
1
Place cardboard underneath the
3
machine to protect it from being
scratched.
2
1
1
1
Qty.
7.1 Unpacking the garden
1
shredder
6
1
2
3
● Open the packaging.
1
Installation position:
1
1 ● Remove the basic unit (A) from the
1
1
● Remove the cardboard insert (1) and
● Place the cardboard insert (1) on the
● Lift the basic unit (A) with the help of a
4.) and follow

7.2 Attaching the chassis

7.) section to avoid
1 Install right and left wheel carrier:
● Raise the basic unit into the assembly
Risk of injury:
Lift the machine only with the help
of a second person. Make sure that
the cardboard insert (1) is not
damaged.
packaging with the help of a second
person and place it on the ground.
place it on the ground. Remove the
wheels (F) and wheel carriers (B, C).
ground with the closed side facing
upwards.
second person and place it on the
cardboard insert as shown.
Risk of injury:
The blade cover must be attached
to prevent any injuries from the
sharp blades. ( 7.4)
position. ( 7.1)
Attach both wheel carriers to the
basic unit in such a way that the
bores for the axle are located at the
rear (on the tool box side).
3
4
55