Placing Tool In Service - Facom V.801 Manual De Instrucciones

V.801 1/04/03 10:41
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
FACOM NS.557
Always use of an air line lubricator with these tools.
We recommend the following Filter- - Lubricator- - Regulator
Unit:
After each eight hours of operation, unless an air- - line
lubricator is used, inject 1/2 cc of the recommended oil
into the air inlet before attaching the hose.
Page 6
WARNING LABEL IDENTIFICATION
Always wear hearing
protection when operating
this tool.
Do not carry the tool by the
hose.
60 psig
Operate at 60 psig (4.2 bar/
(4.2bar/413kPa)
413 kPa) Maximum air pres-
sure.

PLACING TOOL IN SERVICE

WARNING
WARNING
WARNING
International Warning Label
TO MAIN LINES 3 TIMES
AIR AIR TOOL INLET SIZE
SYSTEM
TO
AIR
TOOL
LUBRICATOR
FILTER
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
COMPRESSOR
(Dwg. - -1)