Mobiclinic Libra Manual De Instrucciones página 15

ES EN PT
5. LED indication
- LED(POWER) - GREEN LIGHT ON: Power On.
- LED(CHARGE) - ORANGE LIGHT ON: Charging / GREEN LIGHT ON: Fully Charged
6.Charger Trouble Shooting
(A)If LED (POWER) light is off.
- Check the input voltage (115V/230V) is the same as you adjust.
- If light is still off, please check and repair the battery charger.
(B)If LED (CHARGE) light is off.
- Check to see clips connection is correct.
- If the battery is fully charged, the LED (CHARGE) light will be off.
- If light is still off, the battery may be defective.
(C) If ORANGE light can turn to GREEN.
- The battery can not be charged. Please check and recover it.
(D)If ORANGE light turns to GREEN immediately
- Check to see the battery is fully charged, if not, The battery may be defective Check and recover it.
Batteries must be fully charged in order to not hurt their lifetime. If not, faults may result
ASSEMBLING YOUR SCOOTER
To assemble the scooter, you can repeat the disassembly directions in reverse. Abbreviated directions are given
below:
1. Use the Steering Column Lever to move the Steering Column up out of the way.
2. Tilting the rear end to a horizontal position, insert the scooter frame tube of the front end into the rear section first,
making sure that the locking pins are removed.
3. Slide the two sections of the unit together until the front half reaches its limit.
4.I nsert the two locking pins into their corresponding holes. Both locking pins must be fully inserted whenever the
scooter is assembled.
5. Place batteries, use Velcro to fix the position and attach the battery power plugs.
6. Place rear shroud.
7. Screw together controller wiring harness.
8. Place rear storage cover.
9. Loose Seat Rotation Lever counterclockwise. Place seat on seat post. Tighten Lever again by turning clockwise.
Lock Seat Control Lever on bottom of seat before sitting down.
CLEANING YOUR SCOOTER
If your scooter is dirty, use a damp or lightly soapy cloth to wipe it down. Do not use running water to wash or rinse
the scooter in order to protect the electrical parts. Polish with an automotive liquid polish.
MAINTAINING YOUR SCOOTER
All maintenance and repair of your scooter should be done by an authorized dealer.
The following areas required periodic inspection:
- Tire pressure between 30-50 psi.
- All electrical connections are firmly attached.
FR IT DE
Instruction Manual Libra