Makita DTL062 Manual De Instrucciones página 6

Lighting up the front lamp
CAUTION:
• Do not look in the light or see the source of light
directly.
► 1. Lamp
Pull the switch lever to light up the lamp. The lamp
keeps on lighting while the switch lever is being pulled.
The light automatically goes out 10 - 15 seconds after
the switch lever is released.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
Reversing switch action
1
B
► 1. Reversing switch lever
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch lever cannot be pulled.
CAUTION:
• Always check the direction of rotation before
operation.
• Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
• When not operating the tool, always set the
reversing switch lever to the neutral position.
Always use the correct size socket for bolts and nuts.
An incorrect size socket will result in inaccurate and
inconsistent fastening torque and/or damage to the bolt
or nut.
1
► 1. Socket 2. Anvil
To install the socket, push it onto the anvil of the tool
until it locks into place.
To remove the socket, simply pull it off.
A
► 1. Groove 2. Screw 3. Hook
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
6 ENGLISH
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Selecting correct socket
Installing or removing socket
1
2
Hook (Accessory)
CAUTION:
• When installing the hook, tighten the screw
firmly. Failure to do so may cause the breakage
of the tool or personal injury.
1
2
3