Makita M9400 Manual De Instrucciones página 5

013114
Installing or removing step
1
2
013115
Using step with the tool turned upside down allows
sanding another way of use. Remove the knob and then
place the step on the place the knob was seated and
secure it with knob.
Adjusting belt tracking
013116
While the belt is running, use the adjusting knob to
center the belt tracking. Failure to do so can result in
frayed belt edges and wear on the sander frame.
Dust bag
1
2
013117
The use of the dust bag makes sanding operations
clean and dust collection easy. To attach the dust bag,
fit it onto the dust spout.
1. Step
2. Knob
1. Adjusting knob
1
1. Dust bag
3
2. Fastener
3. Dust spout
When the dust bag is about half full, remove the dust
bag from the tool and pull the fastener out. Empty the
dust bag of its contents, tapping it lightly so as to
remove particles adhering to the insides which might
hamper further collection.
OPERATION
Sanding operation
013118
CAUTION:
The tool should not be in contact with the
•
workpiece surface when you turn the tool on or off.
Otherwise a poor sanding finish or damage of the
belt may result.
Hold the tool firmly with both hands. Turn the tool on
and wait until it attains full speed. Then gently place the
tool on the workpiece surface. Keep the belt flush with
the workpiece at all times and move the tool back and
forth.
Never force the tool. The weight of the tool applies
adequate pressure. Excessive pressure may cause
stalling, overheating of the motor, burning of the
workpiece and possible kickback.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Replacing carbon plate
013119
5
1. Strap washer
2. Cork rubber
plate
3. Carbon plate
1
2
3